to areas that might prove dangerous to a blind person (for example, doors to loading platforms, boiler rooms, stages, and the like) shall be made identifiable to the touch by a textured surface...
Search Results "Extended Floor Surface"
Filters
Commonly Searched Documents
-
4.29.3* TACTILE WARNINGS ON DOORS TO HAZARDOUS AREAS
-
805 Medical Care and Long-Term Care Facilities
Revisions made to this section include: removing a stipulation that wheelchair turning space not extend beneath beds (805.2) clarifying fixture requirements in accessible...
-
The Americans with Disabilities Act Comprehensive Civil Rights Legislation
Nondiscrimination in Public Accommodations Title III of the ADA extends to people with disabilities the same protections that Title II of the Civil Rights Act of 1964 extends to people...
-
II-1.1000 General
It additionally extends the prohibition of discrimination on the basis of disability established by section 504 of the Rehabilitation Act of 1973, as amended, to all activities of State...
-
224.6 Housing at a Place of Education
Kitchens within housing units containing accessible sleeping rooms with mobility features (including suites and clustered sleeping rooms) or on floors containing accessible sleeping rooms...
-
Front grab bar protocol
The preferred grab bar height was measured between the floor and the top of the grab bar surface. ...
-
11B-411.2.1.7.4 Adjacency assignment
Exception: The most adjacent elevator serving the selected floor shall be assigned by hall call consoles located outside the elevator landing....
-
1132A.5.2 Strike edge maneuvering space at doors
The width of the level area on the side to which the door swings shall extend 18 inches (457 mm) past the strike edge for all doors....
-
§27.5 Recipient
organization, or other entity, or any individual in any State, territory, possession, the District of Columbia, or Puerto Rico, to whom Federal financial assistance from the Department is extended...
-
§27.129(e) Content of orders.
will effectuate the purposes of the Act and this part, including provisions designed to assure that no Federal financial assistance to which this regulation applies will thereafter be extended...
-
G.6.ii. - Why isn't undue burden more completely defined in the regulations?
The preamble to the Board's rule included an extended discussion of the term (see 65 FR 80500, at page 80506, December 21, 2000)....
-
12162(d)(1) Remanufacturing
for purposes of section 12132 of this title and section 794 of title 29 for a person to remanufacture a rail passenger car for use in intercity or commuter rail transportation so as to extend...
-
A4.2.1(2) Space Requirements for Use of Walking Aids
Crutch tips, often extending down at a wide angle, are a hazard in narrow passageways where they might not be seen by other pedestrians....
-
A4.2.1(2) Space Requirements for Use of Walking Aids
Crutch tips, often extending down at a wide angle, are a hazard in narrow passageways where they might not be seen by other pedestrians....
-
Knee Clearance: Clearance as Measured from Distal Knee Point - Manual Wheelchair
Hence, to accommodate a particular percentage of users, the side profile of a design element (shown by dotted line) should not extend outside the corresponding shaded area....
-
1015.3 Viewing Space
The viewing space is required to be 32 inches maximum and 51 inches minimum high above the ground and extend the full width of the clear ground space....
-
Knee Clearance: Clearance as Measured from Anterior-Most Abdomen Point - Manual Wheelchair
Hence, to accommodate a particular percentage of users, the side profile of a design element (shown by dotted line) should not extend outside the corresponding shaded area....
-
4. Passenger Vessels
That comment period was extended to January 24, 2014. Once finalized, these guidelines will supplement the Board’s ADA Accessibility Guidelines for Transportation Vehicles....
-
Bobrick Recessed Multi-Roll Toilet Tissue Dispenser B-3888
Extends 2 3⁄4" (70mm) from wall....
-
11B-505.5 Clearance
Clearance between handrail gripping surfaces and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
Tactile Symbols: ADA Standard Section 707.6.3.2
Function key surfaces shall have tactile symbols as follows: Enter or Proceed key: raised circle; Clear or Correct key: raised left arrow; Cancel key: raised letter ex; Add Value key: raised...
-
Dome Size: ADA Standard Section 705.1.1
Truncated domes in a detectable warning surface shall have a base diameter of 0.9 inch (23 mm) minimum and 1.4 inches (36 mm) maximum, a top diameter of 50 percent of the base diameter minimum...
-
11B-707.6.3.2 Tactile symbols
Function key surfaces shall have tactile symbols as follows: Enter or Proceed key: raised circle; Clear or Correct key: raised left arrow; Cancel key: raised letter ex; Add Value key: raised...
-
11B-411.2.1.5.1 Size
Buttons shall have square shoulders, be 3/4 inch (19.1 mm) minimum in the smallest dimension and shall be raised 1/8 inch (3.2 mm) plus or minus 1/32 inch (0.8 mm) above the surrounding surface...
