Such toilet facility may be "unisex" in design....
Search Results "Designed Use"
Filters
Commonly Searched Documents
-
4.1.7(2)(c)
-
1991 Standards
1991 Standards means the requirements set forth in the ADA Standards for Accessible Design, originally published on July 26, 1991, and republished as Appendix D to 28 CFR part 36....
-
1134A.8, Item 3
Cabinets under lavatories are acceptable provided the bathroom has space to allow a parallel approach by a person in a wheelchair and the lavatory cabinets are designed with adaptable knee...
-
11B-407.4.6.2 Buttons
Car control buttons with floor designations shall comply with Section 11B-407.4.6.2. Exception: Reserved....
-
11B-411.2.2.2 Verbal identification
When the accessibility function button is pressed, verbal announcement of the car designation shall be provided at the elevator car entrance upon arrival....
-
Department of Housing and Urban Development under the Fair Housing Act
This rule updates guidelines used to enforce the design requirements of the ADA and the ABA....
-
I. Introduction to the Study
Choosing play surfaces that are accessible upon installation and maintained for accessibility over time becomes one of the most critical decisions during the playground planning and design...
-
Section 36.406(f)(3)
These platforms cover groups of conventional seats and are used to provide groups of wheelchair seats and companion seats....
-
2. Question: What is the minimum width needed for a level boarding railroad passenger station platform to meet the accessibility requirements of the Americans with Disabilities Act (ADA)?
At level boarding platforms, where the gap exceeds plus or minus 5/8 inch vertical or 3 inches horizontal (49 CFR 37.42(f)), a bridge plate is typically used to allow a passenger using a...
-
11B-307.4.1 Guy braces
Where a guy support is used within either the width of a circulation path or 24 inches maximum outside of a circulation path, a vertical guy brace, sidewalk guy or similar device shall be...
-
XI. Overview of Americans with Disabilities Act Accessibility Guidelines for New Construction and Alterations
Every public and common use bathroom must be accessible....
-
Accessible Route
Section 206.7.10 permits the use of platform lifts as an alternative to gangways that are part of accessible routes....
-
Issue 15: How can the potential conflict between the goals of zero net energy and accessibility for low vision persons be resolved?
And I’ve already sent Eunice a contact for someone who certainly advocates with NFPA on stairway design issues, including lighting....
-
Federal Trail Data Standards (FTDS)
Trails of all kinds, including Congressionally and secretarially-designated trails, are strongly recognized by the public and governmental agencies as important recreational and cultural...
-
11B-243.1 General
Where shooting facilities with firing positions are designed and constructed at a site, at least 5 percent, but no fewer than one, of each type of firing position shall comply with Section...
-
1009.2.8 Submerged Depth
The lift shall be designed so that the seat will submerge to a water depth of 18 inches (455 mm) minimum below the stationary water level....
-
1002.5.2 Transfer Height
The height of amusement ride seats designed for transfer shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area....
-
Submerged Depth
Submerged Depth Lifts must be designed so that the seat will submerge to a minimum of 18 inches below the stationary water level....
-
1002.5.2 Transfer Height
The height of amusement ride seats designed for transfer shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area....
-
§27.13(b)(1)
(1) The process for filing a complaint, including the name, address, telephone number, and email address of the employee designated under paragraph (a) of this section, must be sufficiently...
-
§35.171(a)(1)(ii)
(ii) If the agency does not have section 504 jurisdiction, it shall promptly determine whether it is the designated agency under subpart G of this part responsible for complaints filed against...
-
11B-1002.5.2 Transfer height
The height of amusement ride seats designed for transfer shall be 14 inches (356 mm) minimum and 24 inches (610 mm) maximum measured from the surface of the load and unload area....
-
12141(3) Fixed route system
(3) Fixed route system The term "fixed route system" means a system of providing designated public transportation on which a vehicle is operated along a prescribed route according to...
-
243.1 General
Where shooting facilities with firing positions are designed and constructed at a site, at least 5 percent, but no fewer than one, of each type of firing position shall comply with 1010....
