cut-through less 2 inches (51 mm) maximum on each side, placed at the edges of the pedestrian island or cut-through median, and shall be separated by 24 inches (610 mm) minimum of walking surface...
Search Results "Check Writing Surface"
-
11B-705.1.2.3 Islands or cut-through medians
-
Curb Ramps and Blended Transitions (R309.4) (Section-by-Section Analysis)
Detectable warning surfaces are not required on curb ramps and blended transitions that connect the access aisle to the sidewalk, including where the sidewalk is at the same level as the...
-
11B-705.1.2.3 Islands or cut-through medians
cut-through less 2 inches (51 mm) maximum on each side, placed at the edges of the pedestrian island or cut-through median, and shall be separated by 24 inches (610 mm) minimum of walking surface...
-
11B-1007.3.2 Golf club reach range area
This includes accessible routes provided adjacent to or, where provided, on the playing surface of the hole. ◼ ...
-
TTY
When communicating, try to use the same method, e.g., speaking slowly, communicating in writing or with the assistance of an aid or device, etc....
-
2.3(b) Job Analysis and the "Essential Functions" of a Job
: An essential function of a computer programmer job might be described as "ability to develop programs that accomplish necessary objectives," rather than "ability to manually write...
- American Standard Commercial Toilet Seat for Baby Devoro Bowls
-
1013.1 General
Tent pads and tent platforms are defined spaces with prepared surfaces for setting up and securing tents....
-
4.6.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
Refreshment Table
Avoid billowing or long tablecloths that pool on the floor -- wheelchair wheels and tips of canes, crutches, and walkers can easily catch on flowing linens and pull them off surfaces....
-
Landings [4.8.4]
It is recommended that landings of exterior ramps be drained so that water does not accumulate on the surface....
-
Step 2: Identify the Presence of Limiting Factors
What sort of surface is firm and stable? If the answer to both of the following questions is yes, the surface is probably firm and stable....
-
11B-604.8.1.4 Toe clearance
Partition components at toe clearances shall be smooth without sharp edges or abrasive surfaces....
-
General Preamble
For current information / news / updates regarding the status of this and related documents, please check the Updates and News pages....
-
§35.130(b)(8) (Section-by-Section Analysis)
For example, requiring presentation of a driver's license as the sole means of identification for purposes of paying by check would violate this section in situations where, for example,...
-
Advance Notice Only for Particular Services and Equipment
Advance Notice Only for Particular Services and Equipment You may require up to 48 hours’ advance notice and one hour’s advance check-in from a passenger with a disability who wishes...
-
B. TERMS OF AGREEMENT
Mail, return receipt requested or by overnight delivery, a check for $5000.00 to the complainant....
- Bradley 20.6 Gallon Waste Receptacle 355
- Slope : Intercept
- Handbook of Construction Tolerances by David Kent Ballast FAIA, CSI
- Rebuilding Together Of the Triangle - Raleigh, NC
-
M303.2.6 Edge Protection (Section-by-Section Analysis)
Protection), the final rule requires platforms with wheelchair spaces that are raised more than 1½ inches in height to provide a minimum 2-inch-high edge protection, measured from the surface...
-
606.3 Height
Lavatories and sinks shall be installed with the front of the higher of the rim or counter surface 34 inches (865 mm) maximum above the finish floor or ground. EXCEPTIONS: 1....
-
11B-406.5.12 Detectable warnings
width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured from the back of the curb on the ramp surface...




