Exception: Existing elevators with manually operated doors shall not be required to comply with Section 11B-407.3.3....
Search Results "Existing Facility"
2010 ADA Definition
Existing Facility: Existing facility means a facility in existence on any given date, without regard to whether the facility may also be considered newly constructed or altered under this part.
-
11B-407.3.3 Reopening device
-
Primary Function
[35.151(b)(4)(i)] & 36.403(b)] A major activity for which the facility is intended....
-
Is DSA aware of existing precedents (potentially from past experience with non-EV accessible parking) to address the factors that would be considered to determine whether compliance with EV accessibility rules would be technically infeasible?
RESPONSE: A request for technical infeasibility is made to and determined by the local jurisdiction. A request for technical infeasibility is site-specific; therefore, there are no...
-
Additional Information
Department must provide two types of assessments as part of its final rule: an analysis of the costs and benefits of adopting the changes contained in this rule, and a periodic review of its existing...
-
Obstructed High Reach: ADA Standard Section 308.3.2
Section 308.3.2 covers the current ADA Standards for obstructed high side reach.
-
11B-705.1.2.2.2.2 Two entrance/exit points
Existing parallel curb ramps with detectable warnings in compliance with the code requirements in effect at the time of installation shall not be required to provide a minimum 36 inches...
-
11B-308.3.2 Obstructed high reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-705.1.2.2.2.2 Two entrance/exit points
Existing parallel curb ramps with detectable warnings in compliance with the code requirements in effect at the time of installation shall not be required to provide a minimum 36 inches...
-
11B-308.3.2 Obstructed high reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-809.8 Doors
Additional amendments reflect the relocation of existing exceptions in Section 11B-809.8 to Section 11B-809.8.3.1."...
-
§1607.12 Retesting of applicants.
Where examinations are administered periodically with public notice, such reasonable opportunity exists, unless persons who have previously been tested are precluded from retesting....
-
§382.35(b)
Carriers may note pre-existing damage to an assistive device to the same extent that carriers do this with respect to other checked baggage....
-
§ 36.304(d)(3)(i)
(i) In addition to the provisions of section 240.2.1 of the proposed standards, where an existing play area provides elevated play components, an additional number of ground level play components...
-
§ 37.42(c)
(c) For new or altered stations serving commuter, intercity, or high-speed rail lines or systems, in which track passing through the station and adjacent to platforms is shared with existing...
-
3401.1 Scope
The provisions of this chapter shall control the alteration, repair, addition and change of occupancy of existing structures, including state-regulated structures in accordance with Sections...
-
Side Reach [§308.3]
Fuel Dispensers The operable parts of fuel dispensers located on existing curbs can be up to 54” high....
-
§ 37.42(c)
(c) For new or altered stations serving commuter, intercity, or high-speed rail lines or systems, in which track passing through the station and adjacent to platforms is shared with existing...
-
§ 38.93(d)(2) Exception
New vehicles operating in existing stations may have a floor height within plus or minus 11/2 inches of the platform height....
-
Mail Boxes
Mail boxes include, but are not limited to, post office boxes and receptacles provided by commercial mail-receiving agencies, apartment facilities, or schools....
-
Whitehall Mfg. Single Temp Hemispherical Widespread Pushbutton Pneumatic Valve Conical Faucet
Model Number: 3373-WSF The Ligature Resistant Faucet is designed and developed to retrofit existing lavatories or it can be specified for new design....
-
Yale 7000 Series Exit Devices
The 7000 series can be effortlessly integrated into existing security or fire alarm systems to ensure every opening is safeguarded. ...
-
Whitehall Mfg. 3374-8IN Hot & Cold Hemispherical Pushbuttons Pneumatic Valve Conical Faucet 8" Centerset
Model Number: 3374-8IN The Ligature Resistant Faucet is designed and developed to retrofit existing lavatories or it can be specified for new design....
-
Whitehall Mfg. Single Temp Hemispherical Pushbutton Pneumatic Valve Conical Faucet 4” Centerset
The Ligature Resistant Faucet is designed and developed to retrofit existing lavatories or it can be specified for new design....
-
Whitehall Mfg. Hot & Cold Piezo Widespread Pushbutton Electronic Valve Conical Faucet
Model Number: 3374-PPZ-WSF The Ligature Resistant Faucet is designed and developed to retrofit existing lavatories or it can be specified for new design....
