This document contains scoping and technical requirements for accessibility to sites, facilities, buildings, and elements by individuals with disabilities....
Search Results "Fire-Building Surface"
Filters
Commonly Searched Documents
-
101.1 General
-
Floor Naming and Numbering
This is a little abstract one, but if you look at those elevator buttons, whether you’re in a building in San Francisco and you come in on the east side of the building and it’s Floor Level...
-
68.70. Registered Accessibility Specialists--Qualifications for Certification
inspection, building planning, accessibility design or review, accessibility inspection, or equivalent; or (B) eight years experience related to building inspection, building planning...
-
After January 26, 1992
Altering (renovating) a building means making a change in the usability of the altered item....
-
Assisted Living Directory - Texas Assisted Living Facilities & Senior Care Search
Type E facilities are similar to Type A, but are limited to no greater than 16 beds, and don’t need to have the same type of fire alarm system that Type A facilities are....
-
Edge Protection
Edge Protection Where railings, guards, or handrails are provided, edge protection must be provided and extend a minimum of 2 inches above the ground or deck surface....
-
22. How can I get copies of the ASTM standards that apply to play areas?
American Society for Testing and Materials, 100 Bar Harbor Drive, West Conshohocken, Pennsylvania 19428, www.astm.org: ASTM F 1292-99 Standard Specification for Impact Attenuation of Surface...
-
SEAT HEIGHT MEASUREMENT DETAIL
Note that examination tables and chairs only use bolsters on certain areas of the transfer surface....
-
1.3.2 Focus Following NPRM Comments
This review identified four major issue areas for the MDE Advisory Committee to address, as follows: Transfer surface height and size Permitted obstructions to the transfer surface...
-
I. Public Toilet Rooms
In all public and common use toilet rooms throughout the Hotel and the Tower, Defendants will provide at least one lavatory with a counter-top that is 34 inches above the finish floor surface...
-
Card Catalogs and Magazine Displays [8.4]
Requirements for fixed counters and tables [4.32] specify a surface height (34 inches maximum) and knee clearance below appropriate for extended use as a writing/work surface....
-
F206.4.3 Entrances from Tunnels or Elevated Walkways
Where direct access is provided for pedestrians from a pedestrian tunnel or elevated walkway to a building or facility, at least one direct entrance to the building or facility from each...
-
Sec. 469.106(b)
(b) The department and the Texas Building and Procurement Commission shall ensure compliance with the standards and specifications described by Subsection (a) for a building or facility...
-
206.4.3 Entrances from Tunnels or Elevated Walkways
Where direct access is provided for pedestrians from a pedestrian tunnel or elevated walkway to a building or facility, at least one direct entrance to the building or facility from each...
-
1.1.3.2, Item 11
Public elementary and secondary schools, community college buildings and state-owned or state-leased essential service buildings regulated by the Division of the State Architect....
-
Slope
The incline of a surface....
-
Slope
The incline of a surface. ...
-
IMPLICATION OF A 19-INCH MINIMUM STANDARD FOR THE HIGHEST POINT IN THE LOWEST ADJUSTABLE POSITION
However, shorthand references to 19 inches as the minimum standard as used in this minority report should not be equated with a 19-inch transfer surface height, for two major reasons....
-
¼ Inch Minus Limestone
The surface was installed in two rolled and compacted 3 inch lifts....
-
Areas for further work
Areas for further work In the process of assisting the various organizations that represent surface materials and professional groups the following issues were identified as parameters...
-
1.1.3.2, Item 9
Permanent buildings and permanent accessory buildings or structures constructed within mobile-home parks and special occupancy parks regulated by the Department of Housing and Community...
-
1.2 Compliance with New Construction Requirements
1.2 Compliance with New Construction Requirements: The basic work of any project, whether new construction, an addition to an existing building or facility or an alteration of an existing...
-
11B-803.6 Mirrors
Mirrors shall be installed with the bottom edge of the reflecting surface 20 inches (508 mm) maximum above the finish floor or ground....
-
1011.2.4 Openings
Openings in the clear ground space surface shall not allow the passage of a sphere more than 1/2 inch (13 mm) in diameter. Advisory 1011.2.4 Openings. ...
