width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured from the back of the curb on the ramp surface...
Search Results "Surface Slope"
Filters
Commonly Searched Documents
-
11B-406.5.12 Detectable warnings
-
11B-308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
11B-705.1.2.3 Islands or cut-through medians
cut-through less 2 inches (51 mm) maximum on each side, placed at the edges of the pedestrian island or cut-through median, and shall be separated by 24 inches (610 mm) minimum of walking surface...
-
3. Camera
Consider taking additional photos of the digital level showing slope and cross slope measurements of walkways and ramps as well as photos showing exactly where the digital level was placed...
-
Develop a Transition Plan
Where a public entity has responsibility or authority over streets, roads, or walkways, its transition plan must include a schedule for providing curb ramps or other sloped areas where pedestrian...
-
A) Accessible Parking
Access aisle of at least 60-inch width must be level (1:50 maximum slope in all directions), be the same length as the adjacent parking space(s) it serves and must connect to an accessible...
-
11B-206.2.1 Site arrival points
(1) Newly constructed or altered streets, roads, and highways must contain curb ramps or other sloped areas at any intersection having curbs or other barriers to entry from a street...
-
Section D: Entrances
(§404.2.4) D4 Is the area in front of the door level, with slopes no greater than 1:48 in all directions?...
-
Using the ORAR Exceptions [F202.3, Exception 4 and 1016, Exceptions 1, 2, and 3]
When an ORAR is provided within the roadway, it is exempted from the technical requirements for cross slope, running grade, resting intervals, and passing spaces....
-
Boating facilities. (Section-by-Section Analysis)
attached to land) are involved, a number of exceptions are provided from the general standards for accessible routes in order to take into account the difficulty of meeting accessibility slope...
-
OTHER SPECIFIC BARRIERS
Some of the barriers identified in Exhibit A are so severe that they constitute safety hazards to persons with mobility disabilities, including curb ramps with running slopes greater than...
-
Boating facilities. (Section-by-Section Analysis)
attached to land) are involved, a number of exceptions are provided from the general standards for accessible routes in order to take into account the difficulty of meeting accessibility slope...
-
407.12.3.2.2 Knee and Toe Space (Section-by-Section Analysis)
Building on this exception, the second exception would allow further reduction in the height of the space along the profile of the knee to the toe sloping at 6:1 toward the maximum protrusion...
-
Part 1. Typical Issues for Voters Who Use Wheelchairs, Scooters or Other Mobility Aids
Abrupt level changes, steps, or steeply sloped sidewalks cannot be part of an accessible route. Where ramps are used, they cannot be steeper than 1:12....
-
11B-233.3.1.2.6.1 Single building with one common (lobby) entrance
Test No. 1 -- Individual Building Test may only be used if the site has terrain over 15 percent slope. Test No. 3 -- Unusual Characteristics Test may be used if applicable....
-
Stanley FBB 266 Heavy Weight Ball Bearing “Swing Clear” Offset Door Hinge
clear 90° Equipped with four Stanley permanently lubricated non-detachable ball bearings Pins in nonferrous hinges are stainless steel Heavy weight gauges increase available bearing surface...
-
Stanley FBB 268 Heavy Weight Ball Bearing “Swing Clear” Offset Door Hinge
clear 90° Equipped with four Stanley permanently lubricated non-detachable ball bearings Pins in nonferrous hinges are stainless steel Heavy weight gauges increase available bearing surface...
-
Stanley FBB 264 Heavy Weight Ball Bearing “Swing Clear” Offset Door Hinge
clear 90° Equipped with four Stanley permanently lubricated non-detachable ball bearings Pins in nonferrous hinges are stainless steel Heavy weight gauges increase available bearing surface...
-
Stanley FBB 269 Heavy Weight Ball Bearing “Swing Clear” Offset Door Hinge
clear 90° Equipped with four Stanley permanently lubricated non-detachable ball bearings Pins in nonferrous hinges are stainless steel Heavy weight gauges increase available bearing surface...
-
Function Keys
It included specifications for key surfaces to be raised 1/25 inch minimum and that outer edges have a radius of 1/50 inch maximum (707.4.2)....
-
Best Practices
Surface conditions, slopes, landings and detectable warnings are all rated using a 1-5 system, and the data is entered into the city geographic information system (GIS)....
-
Kuriki 2-in-One Paper Holder
The SL 2-in-ONE Paper Holder features a built-in surface placed next to the toilet paper holder, offering both style and convenience....
-
Salsbury Industries See Through Metal Locker Six Tier Box Style Bridge 16 Box
Requires the Registered User plan or above. Login! -
Grab Bars
The top of the gripping surface must be 4 to 6 inches above the wall to provide leverage to the person using the bars....
