The landing provides an area for users to exit the curb ramp and proceed along the walking surface at the top of the curb ramp....
Search Results "Surface Hazard"
Filters
Commonly Searched Documents
-
11B-406.5.3 Landings
-
Toilet Paper Dispensers
This may effectively preclude some dispensers from being located above grab bars in view of the minimum mounting height of grab bars (33 inches, measured to the top of the gripping surface...
-
Issue 5: Tactile arrow (in line)
Figure 13: APS installed on poles in the landscape strip, and still within reach from a level paved sidewalk surface....
-
Q2.) What are the types of “field conditions” that were anticipated where the advisory says “tolerances recognized by this provision include those for field conditions”?
And a concrete finisher clearly cannot guarantee that the slope of a concrete curb ramp will be consistently 8.33% across its entire surface. ...
-
606.2 Clear Floor Space
clearance of 24 inches (610 mm) minimum above the finish floor or ground shall be permitted at lavatories and sinks used primarily by children 6 through 12 years where the rim or counter surface...
-
Ground-Level Accessible Routes
At ground level, objects may not protrude into the 60-inch wide space of an accessible route up to or below the height of 80 inches (2030 mm), measured above the accessible route surface...
-
5. Conflicts Between Shared Path Users
The comments also recommended design solutions to avoid conflicts between users, including separate pathways for pedestrians and bicyclists; and detectable warning surfaces at intersections...
-
b. Positioning Supports
Section-by-Section Analysis – M305.2), the MDE Advisory Committee made recommendations to add requirements for positioning supports on mammography equipment and imaging equipment with transfer surfaces...
-
606.2 Clear Floor Space
clearance of 24 inches (610 mm) minimum above the finish floor or ground shall be permitted at lavatories and sinks used primarily by children 6 through 12 years where the rim or counter surface...
-
Existing Trails [F247.2]
the trail; clearing the trail of encroaching brush or grasses; and removing rock slides Maintaining trail tread, such as filling ruts, reshaping a trail bed, repairing a trail surface...
-
Medical Diagnostic Equipment Accessibility Standards Sub-Committee Recommendations Weight Scales
Types Of Equipment To Which Technical Criteria Applies Seated in a wheelchair (M303) Wheelchair space, including orientation, width, depth, knee and toe clearance, and surface...
-
R209 Accessible Pedestrian Signals and Pedestrian Pushbuttons (Section-by-Section Analysis)
., audible tones and vibrotactile surfaces) to pedestrians who are blind or have low vision....
-
R410.6 Character Height
Table R410.6 Visual Character Height Height to Finish Surface from Baseline of Character Horizontal Viewing Distance Minimum Character Height 1.0 m (3.3...
-
"Other Power-Driven Mobility Device" (Section-by-Section Analysis)
designed for areas or conditions without defined pedestrian areas, such as off-road bike paths, roads (except where allowed by law or where a sidewalk is not provided), freeways, or natural surfaces...
-
606.2 Clear Floor Space
clearance of 24 inches (610 mm) minimum above the finish floor or ground shall be permitted at lavatories and sinks used primarily by children 6 through 12 years where the rim or counter surface...
-
Trail Facilities
not accessible— must be designed to comply with the applicable provisions in FSORAG, except that slopes not steeper than 1:20 (5 percent) are allowed if necessary for drainage of unpaved surfaces...
-
1018.1 General
The technical requirements address connections (1018.2); surface (1018.3); clear width (1018.4); obstacles (1018.5); openings (1018.6); slopes, including running slope (1018.7.1) and cross...
-
Developing a plan based on priorities
In order to promote safety, a portable ramp should be properly secured; have railings; and a firm, stable, nonslip surface....
-
Waviness Index
The Waviness Index measures the bumps and dips in a floor surface as the average of deviations up or down from the mid - points of 2 - , 4 - , 6 - , 8 - , and 10 - foot chords....
-
Positioning Supports Considered
., length, height above the patient support surface, location) to ensure their effectiveness?...
-
11B-604.8.1.4 Toe clearance
Partition components at toe clearances shall be smooth without sharp edges or abrasive surfaces....
-
11B-604.8.1.4 Toe clearance
Partition components at toe clearances shall be smooth without sharp edges or abrasive surfaces....
-
Activar JL Industries Cosmopolitan Series 2035S21 Stainless Steel Fire Extinguisher Cabinet
Surface-mount has a square edge or optional rolled edge upon request. 1 3/4" face trim on frame and 1 1/4" trim on door....
-
American Standard AccessPRO Toilet
less water Meets EPA WaterSense® criteria PowerWash® rim scrubs bowl with each flushRobust metal trip lever & metal shank fill valveIncludes adjustable trapway kit EverClean® surface...
