The design of non-rail vehicles shall be coordinated with the boarding platforms to minimize the gap between the vehicle floor and the boarding platforms....
Search Results "Seat Designation"
-
T404.2 Vehicle Floor and Boarding Platform Coordination
-
4(2)(b)
(b) Design features such as sunken or raised functional areas do not interrupt the accessible route through the remainder of the dwelling unit....
-
§ 35.152(b)(2)(ii)
(ii) Should not place inmates or detainees with disabilities in designated medical areas unless they are actually receiving medical care or treatment;...
-
4.24.7 Faucets
Lever-operated, push-type, touch-type, or electronically controlled mechanisms are acceptable designs....
-
9.4 Other Sleeping Rooms and Suites
Doors and doorways designed to allow passage into and within all sleeping units or other covered units shall comply with 4.13.5....
-
4.34.3 ADAPTABILITY
Accessible dwelling units may be designed for either permanent accessibility or adaptability....
-
Depth
The design allowed one to reach inside through the columns to some degree....
-
4.24.7 FAUCETS
Lever-operated, push-type, touch-type, or electronically controlled mechanisms are acceptable designs....
-
Vehicle Parking Lot
An area specifically intended for parking of more than two motor vehicles, usually divided into multiple designated parking spaces. ...
-
§100.205(e)(2)
(2) The following also qualify as HUD-recognized safe harbors for compliance with the Fair Housing Act design and construction requirements:...
-
BOAT LAUNCH RAMP
[DSA-AC] A sloped surface designed for launching and retrieving trailered boats and other water craft to and from a body of water....
-
2010 Standards
2010 Standards means the 2010 ADA Standards for Accessible Design, which consist of the 2004 ADAAG and the requirements contained in §35.151....
-
§ 35.152(b)(2)(ii)
(ii) Shall not place inmates or detainees with disabilities in designated medical areas unless they are actually receiving medical care or treatment;...
-
PERMANENT
[DSA-AC] Facilities which, are intended to be used for periods longer than those designated in this code under the definition of “Temporary.”...
-
PERMANENT
[DSA-AC] Facilities which, are intended to be used for periods longer than those designated in this code under the definition of “Temporary.”...
-
BOAT LAUNCH RAMP
[DSA-AC] A sloped surface designed for launching and retrieving trailered boats and other water craft to and from a body of water....
-
11B-608.2.2.1 Clearance
minimum side of the clearance provided that it is not on the side of the clearance adjacent to the controls or, where provided, not on the side of the clearance adjacent to the shower seat...
-
18. Where an existing ground level play component is replaced, should the new component comply with the technical provisions of Section 1008.4 even if there is not an accessible route to it?
In this case, the spring rocker being replaced would need to have the rocker seat height between 11 and 24 inches and clear floor or ground space and maneuvering space provided adjacent...
-
Receivers and Couplers
Receivers and Couplers ADAAG requires that receivers be provided to serve at least 4% of the total number of seats (but in no case fewer than two)....
-
Motorized Kick Scooters
Motorized scooters usually have hand brakes and often have larger, pneumatic rubber tires; and some have pedestal seats....
-
GH1 Ceiling Lift 3D Demonstration
Planned and designed with pcon planner (free download at www.pcon-planner.com)....
-
Landscape Forms Inc. Olithas Outdoor Tables and Benches Video
This video shows functionality and design of the Olithas Outdoor Tables and Benches by Landscape Forms Inc....
-
G.3.ii. - Are some types of secure electronic equipment, such as secure telecommunications devices that are specifically designed to prevent eavesdropping and other forms electronic attack, subject to Section 508 requirements?
Unless an exception applies, these technologies are considered EIT and must meet the Access Board standards. If "Tempest-tested" telecommunications systems are being used in an...
-
24.1 Q. What types of grab bars should the reinforcement be designed to accommodate and what types may be used if the builder elects to install grab bars in some units at the time of construction?
A. The Guidelines do not prescribe the type of product for grab bars, or the structural strength for grab bars. The Guidelines only state that the necessary reinforcement must be...
