Each car shall automatically stop at a floor landing within a tolerance of ½ inch (12.7 mm) under rated loading to zero loading conditions....
Search Results "Ground Floor Exit"
Commonly Searched Documents
-
11B-409.4.4 Leveling
-
11B-707.7.1 Visibility
The display screen shall be visible from a point located 40 inches (1016 mm) above the center of the clear floor space in front of the machine....
-
11B-409.4.4 Leveling
Each car shall automatically stop at a floor landing within a tolerance of ½ inch (12.7 mm) under rated loading to zero loading conditions....
-
412.2.6 Accessibility
[DSA-AC] In air traffic control towers, an accessible route shall not be required to serve the cab and the equipment areas on the floor immediately below the cab....
-
F105.2.2 ASME
The provisions for escalators require that at least two flat steps be provided at the entrance and exit of every escalator and that steps on escalators be demarcated by yellow lines 2 inches...
-
216 Signs
The sign shall be illuminated when exit sign illumination is required....
- AquaTrek2 ADA Ladder System
-
Are there any situations in which an animal would not be permitted to accompany its user on the flight?
., an aisle, access to an emergency exit) AND the passenger and animal cannot be moved to another location where such a blockage does not occur....
-
11B-106.5 Defined terms
CCR Clear Comply with Disability Element Enforcing Agency Exit...
-
Section 4.1.1, Application (Preamble, Section-by-Section Analysis)
principle of the proposed rule: Areas that may be used by employees with disabilities shall be designed and constructed so that an individual with a disability can approach, enter, and exit...
-
Technical Memorandum TM 2012-01 Electric Vehicle Charging Stations
shall be at least 96 inches wide and shall provide a 36 inch wide (minimum) accessible route complying with TAS 402 on both sides of the vehicle space to allow the user adequate space to exit...
-
1. Typical Issues
Accessible parking spaces need an adjacent access aisle that provides space for a person with a mobility disability to exit their vehicle....
-
Section 4.1.1, Application (Section-By-Section Analysis and Response to Comments)
principle of the proposed rule: Areas that may be used by employees with disabilities shall be designed and constructed so that an individual with a disability can approach, enter, and exit...
-
11B-106.5 Defined terms
CCR Clear Comply with Disability Element Enforcing Agency Exit...
-
11B-406.5.3 Landings
The landing provides an area for users to exit the curb ramp and proceed along the walking surface at the top of the curb ramp....
-
1016.4 Passing Spaces
where the route is heavily used or adjoins elements, spaces, or facilities that are heavily used; or where the route is a boardwalk or otherwise not at the same level as the adjoining ground...
-
III-8.2000 Private suits
Also, when a person has reasonable grounds for believing that he or she is "about to be subjected to discrimination" because of a violation of the new construction and alterations requirements...
-
1. Side grab bar
Side grab bar: There is a grab bar on the adjacent side wall that is at least 40 inches long and from 33 to 36 inches above the floor....
-
708.4 Residential Dwelling Unit Communication Systems
Communications systems between a residential dwelling unit and a site, building, or floor entrance shall comply with 708.4....
-
409.4.4 Leveling
Each car shall automatically stop at a floor landing within a of 1/2 inch (13 mm) under rated loading to zero loading conditions....
-
5.1.4 Transfer Surface Height Measurement
The transfer surface height should be measured from the floor to the highest point on the seat in an uncompressed state, inclusive of bolsters....
-
T304.2 Height
Operable parts shall be located 24 inches (610 mm) minimum and 48 inches (1220 mm) maximum above the floor of non-rail vehicles....
-
4. Overhead Objects
4 Is the voting area free of overhead objects that voters may pass under with the bottom edge lower than 80 inches above the floor? Yes _____ No _____...
-
4.18.4 Flush Controls
Flush controls shall be hand operated or automatic, and shall comply with 4.27.4, and shall be mounted no more than 44 in (1120 mm) above the finish floor....