1.16 "Traditional, sloped-floor" or "traditional seating" shall mean and refer to the section of an auditorium in which the seats are not affixed on risers, but are instead affixed to...
Search Results "Clear Floor Area"
-
1.16 Traditional, sloped-floor or traditional seating
-
502.4 Floor or Ground Surfaces
Advisory 502.4 Floor or Ground Surfaces. Access aisles are required to be nearly level in all directions to provide a surface for wheelchair transfer to and from vehicles....
-
H. Drop-off Area Height
Is the height of the covered passenger pickup/drop-off area at least 9'−6" to allow vans with raised roofs to use such area?...
-
SETTLEMENT AGREEMENT BETWEEN AND AMONG THE UNITED STATES OF AMERICA, [redacted], THE CITY OF HARTFORD, et al., UNDER THE ADA
SETTLEMENT AGREEMENT BETWEEN AND AMONG THE UNITED STATES OF AMERICA, [redacted], THE CITY OF HARTFORD, CONNECTICUT INNOVATIONS, INC., AEG MANAGEMENT CT LLC, NORTHLAND TRUMBULL BLOCK...
- Marquette Area Autism Spectrum Support
-
Aisle Stairs and Ramps in Assembly Areas
Aisle Stairs and Ramps in Assembly Areas....
-
502.4 Floor or Ground Surfaces
Advisory 502.4 Floor or Ground Surfaces. Access aisles are required to be nearly level in all directions to provide a surface for wheelchair transfer to and from vehicles....
-
405.9.1 Extended Floor or Ground Surface
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505....
-
Summary of Major Provisions
The final rule applies to the following federal agencies and their components that administer outdoor areas developed for recreational purposes: Department of Agriculture (Forest Service...
-
Federal Aviation Administration Draft Advisory Circular 150/5360-14A, Access to Airports by Individuals with Disabilities
To assist airports in providing required Service Animal Relief Areas (SARA), this AC provides a set of standards recommended for SARAs at all civil use airports....
-
11B-405.4 Floor or ground surfaces
Floor or ground surfaces of ramp runs shall comply with Section 11B-302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
11B-405.4 Floor or ground surfaces
Floor or ground surfaces of ramp runs shall comply with Section 11B-302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
11B-405.4 Floor or ground surfaces
Floor or ground surfaces of ramp runs shall comply with Section 11B-302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
703.4.1 Height above Finish Floor or Ground
703.4.1 Height above Finish Floor or Ground....
-
Areas for further work
Areas for further work In the process of assisting the various organizations that represent surface materials and professional groups the following issues were identified as parameters...
-
Toilet Rooms-Banquet Area
Toilet Rooms-Banquet Area: s....
-
2.1 General
ORARs shall be provided between units and constructed features in campgrounds, picnic areas, trailheads, viewing areas, and other outdoor recreation sites....
-
703.4.1 Height above Finish Floor or Ground
Tactile characters on signs shall be located 48 inches (1220 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest tactile character and 60 inches...
- Tormax Technologies iMotion® TN 110 In-Floor Swing Door Operator (High and Low Energy)
-
809.5.6 Site, Building, or Floor Entrance
809.5.6 Site, Building, or Floor Entrance....
-
703.5.6 Height from Finish Floor or Ground
703.5.6 Height from Finish Floor or Ground. Visual characters shall be 40 inches (1015 mm) minimum above the finish floor or ground....
-
1134A.5, Item 1
The edge of the clear floor space shall be flush with the control wall surface....
-
1134A.5, Item 1
The edge of the clear floor space shall be flush with the control wall surface....
-
Stabila, Inc. Magnetic TECH Digital Electronic Level Video
Requires the Registered User plan or above. Login!