Provide minimum vertical clearance of 114 in (2895 mm) at accessible passenger loading zones and along at least one vehicle access route to such areas from site entrance(s) and exit(s)....
Search Results "Assembly Area"
Commonly Searched Documents
-
4.6.5* Vertical Clearance
-
Problem Two
As a temporary solution for election day, use traffic cones to mark off the access aisle and curb ramp area....
-
106.5.57 Safe Harbor
1, 1994 Texas Accessibility Standards (TAS) are not required to be retrofitted to reflect the incremental changes in the 2012 TAS solely because of an alteration to a primary function area...
-
R308.1 Transit Stops
Where security bollards are installed at transit stops, they must not obstruct the clear space at boarding and alighting areas or reduce the required clear width at pedestrian access routes...
-
F106.5 Defined Terms
to this section for the following terms: boards, camp shelter, camping facility, camping unit, outdoor constructed features, picnic facility, picnic unit, trail, trailhead, and viewing areas...
-
4.34.6.5(1)
The total width of sink and counter area shall be 30 in (760 mm)....
-
III-7.8300 Medical care facilities
In medical care facilities, all public and common use areas must be accessible....
-
11B-812.7.2 Marking
The area within the borderlines shall be marked with hatched lines a maximum of 36 inches (914 mm) on center....
-
11B-407.2.2.2 Visible signals
Signals shall be visible from the floor area adjacent to the hall call button. Exceptions: 1. Reserved. 2. Reserved. [2010 ADAS] 2....
-
§ 38.159(c)(1) Design load
Ramps 30 inches (760 mm) or longer shall support a load of 600 pounds (2665 N), placed at the centroid of the ramp distributed over an area of 26 inches by 26 inches (660 mm by 660 mm),...
-
11B-407.2.2.2 Visible signals
Signals shall be visible from the floor area adjacent to the hall call button. Exceptions: Reserved. Reserved. [2010 ADA Standards] 2....
-
11B-217.5 Shelves for portable TTYs
Exceptions: Secured areas of detention and correctional facilities where shelves and outlets are prohibited for purposes of security or safety shall not be required to comply with...
-
ALTERATION
ETA Editor's Note [ADA Title III §36.403(c)] Alterations to an Area Containing a Primary Function. (See “Primary Function.”)...
-
11B-223.1.1 Alterations
As a facility is altered over time, every effort should be made to disperse accessible patient bedrooms or resident sleeping rooms among patient care areas such as pediatrics, cardiac care...
-
11B-806.2.4 Toilet and bathing facilities
Toilet and bathing fixtures required to comply with Sections 11B-603 through 11B-610 shall be permitted to be located in more than one toilet or bathing area, provided that travel between...
-
Rulemaking History
Some addressed areas that had not been specifically covered by an access standard or code before....
-
Boundaries of Angled Parking Spaces
triangular sections" at the head of the stall and the foot of the stall could have slopes > 1:48 and possibly have a column in these locations (see sketch) - it would seem that these areas...
-
11B-217.5 Shelves for portable TTYs
Secured areas of detention and correctional facilities where shelves and outlets are prohibited for purposes of security or safety shall not be required to comply with Section 11B-217.5....
-
Plan the room set-up
Identify an integrated seating area for attendees that are deaf or hearing impaired. Refer to the U.S....
-
Outdoor Recreation Access Routes at Trailheads [F247.3.2]
ORARs provide greater accessibility than a trail because areas served by ORARs are typically more developed than trails....
-
T402.2 Design Load
Ramps and bridgeplates 30 inches (760 mm) or more in length shall be designed to support a load of 600 pounds (273 kg) minimum, placed at the centroid of the ramp distributed over an area...
-
Guidance on permissible service animals.
Due to the proliferation of animals used by individuals, including wild animals, the Department believes that this area needs some parameters. ...
-
604.8.2.2 Doors
Toilet compartment doors shall not swing into the minimum required compartment area....