Section 903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....
Search Results "Wheelchair Space (Assembly)"
2010 ADA Definition
Wheelchair Space (Assembly): Space for a single wheelchair and its occupant.
Filters
Commonly Searched Documents
-
General: ADA Standard Section 803.1
-
Clear Tread Width [1017.3]
Where gates and barriers require users to make 90-degree or 180-degree turns, sufficient space should be provided for people using mobility devices to make the turns (figure 3)....
-
3.3.11 180-Degree Turn
The space requirements for a 180-degree turn are similar across countries, ranging from 1500 mm (59 in.) in the U.K. and Canada to 1540 mm (60.6 in.) in Australia....
-
Station 1-Physical Characteristics
Wheel spacing-measured from the center of one outside wheel to the center of the other outside wheel....
-
Pilot Rock UT Series Side Accessible Picnic Table Using Recycled Plastic
A section of seating is removed from the side(s) for ADA COMPLIANT wheelchair accessibility right in the middle of activities. ...
-
Accessible Routes
Accessible Routes An accessible route is a pathway specifically designed to provide access for individuals with disabilities, including those using wheelchairs or mobility devices....
-
F202.3 Alterations
Where existing elements or spaces are altered, each altered element or space shall comply with the applicable requirements of Chapter 2. EXCEPTIONS: 1....
-
11B-411.2.1.3.4 Position
The face of hall call console assemblies and the face of touch screens shall be sloped away from the user at 7 to 25 degrees from the vertical plane....
-
Press Boxes [§206.2.7]
Press Boxes [§206.2.7] An accessible route is required to press boxes except where the aggregate area of all press boxes serving a playing field or assembly area is no more than 500 sq...
-
2.2 Key Measurement Variables and Procedures
Demographic information and wheelchair description: Approximately 30 variables recorded with a checklist, along with digital still photographs of the user and mobility device. 2....
-
M304 Diagnostic Equipment Used by Patients in Standing Position
., standing position, seated position, and seated in a wheelchair)....
-
11B-803.1 General
Section 11B-903.5 requires dressing room bench seats to be installed so that they are at the same height as a typical wheelchair seat, 17 inches (430 mm) to 19 inches (485 mm)....
-
9. Exterior Ramps
have the following features: a. top and bottom landings that are level, at least as wide as the ramp they serve, and at least 60" long to allow for adequate maneuvering and resting space...
-
Kitchen Cabinets
With a remodel, they can be lowered to 32” a.f.f. for wheelchair users 10” removable drawer in the kick space to lower the cabinets for wheelchair users Self-closing drawers...
-
16. If a play surface is replaced with an accessible surface and the existing ground level play components are not accessible, do the components need to be replaced?
If the alteration to the play area only involves the surfacing, only the surface along accessible routes, clear floor or ground spaces, and maneuvering spaces must comply with the ASTM F...
-
Slope : Intercept
They form a suite of objects for installation in public space, both as a mode of critical play and critical access....
-
TABLE OF CONTENTS
202 Existing Buildings and Facilities 203 General Exceptions 204 Protruding Objects 205 Operable Parts 206 Accessible Routes 207 Accessible Means of Egress 208 Parking Spaces...
-
Maneuvering Clearances at Doors [4.13.6]
Maneuvering Clearances at Doors [4.13.6] Pull-side clearance beyond the door swing provides space for a forward reach to door hardware....
-
Section 4.1.3, Accessible Buildings: New Construction (Preamble, Section-by-Section Analysis)
Paragraph 19, covering assembly areas, specifies the number of wheelchair seating spaces and types and numbers of assistive listening systems required....
-
Section 4.1.3, Accessible Buildings: New Construction (Section-By-Section Analysis and Response to Comments)
Paragraph 19, covering assembly areas, specifies the number of wheelchair seating spaces and types and numbers of assistive listening systems required....
-
Section 37.93 One Car Per Train Rule
statutory directive that all rail operators (light, rapid, commuter and intercity) have at least one car per train accessible to persons with disabilities, including individuals who use wheelchairs...
-
Kompan, Inc. Electronic Playgrounds ICON1012 Space Video
This is a short video of the electronic interactive play ground equipment by Kompan Inc.
-
4.1.4(7) FACTORY INDUSTRIAL
Factory industrial occupancy includes, among others, the use of a building or structure, or portion thereof, for assembling, disassembling, fabricating, finishing, manufacturing, packaging...
-
ACCESSIBLE ROUTE
[DSA-AC & HCD 1-AC] A continuous unobstructed path connecting accessible elements and spaces of an accessible site, building or facility that can be negotiated by a person with a disability...
