Agreement is determined to be invalid, unenforceable, or otherwise contrary to applicable law, such provision shall be deemed restated to reflect as nearly as possible, and to the fullest extent...
Search Results "Maximum Extent Practicable"
Filters
Commonly Searched Documents
-
III. IMPLEMENTATION AND ENFORCEMENT
-
III. IMPLEMENTATION AND ENFORCEMENT
Agreement is determined to be invalid, unenforceable, or otherwise contrary to applicable law, such provision shall be deemed restated to reflect as nearly as possible, and to the fullest extent...
-
IMPLEMENTATION AND ENFORCEMENT
Agreement is determined to be invalid, unenforceable, or otherwise contrary to applicable law, such provision shall be deemed restated to reflect as nearly as possible, and to the fullest extent...
-
IMPLEMENTATION AND ENFORCEMENT
Agreement is determined to be invalid, unenforceable, or otherwise contrary to applicable law, such provision shall be deemed restated to reflect as nearly as possible, and to the fullest extent...
-
IMPLEMENTATION AND ENFORCEMENT
Agreement is determined to be invalid, unenforceable, or otherwise contrary to applicable law, such provision shall be deemed restated to reflect as nearly as possible, and to the fullest extent...
-
IMPLEMENTATION AND ENFORCEMENT
Agreement is determined to be invalid, unenforceable, or otherwise contrary to applicable law, such provision shall be deemed restated to reflect as nearly as possible, and to the fullest extent...
-
IMPLEMENTATION AND ENFORCEMENT
Agreement is determined to be invalid, unenforceable, or otherwise contrary to applicable law, such provision shall be deemed restated to reflect as nearly as possible, and to the fullest extent...
-
3.2 Projects with Adjusted Construction Costs Above the Valuation Threshold
• "Compliance shall be provided by equivalent facilitation or to the greatest extent possible without creating an unreasonable hardship; but in no case shall the cost of compliance...
-
Economic and Technical Impacts
To what extent does diagnostic equipment currently incorporate features that conform to the technical criteria proposed in Chapter M3?...
-
Intent
It includes 2016 CBC Chapter 11A - Housing Accessibility requirements only to the extent that these have been adopted by DSA-AC for applicability to Public Housing. ...
-
The IRIS Center - Peabody College Vanderbilt University
Our primary objective is to create resources about evidence-based practices for use in preservice preparation and professional development programs....
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
The symbol shall be mounted at 58 inches (1473 mm) minimum and 60 inches (1524 mm) maximum above the finish floor or ground surface measured from the centerline of the symbol....
-
382.133 What are the requirements concerning the evaluation and use of passenger-owned electronic devices that assist passengers with respiration in the cabin during flight and do not contain hazardous materials?
Carriers may insist on passengers bringing on board fully charged batteries adequate to last for 150 percent of the expected maximum flight duration....
-
1115B.8.4
shall be located on the wall within 12 inches (305 mm) of the front edge of the toilet seat, mounted below the grab bar, at a minimum height of 19 inches (485 mm), and 36 inches (914 mm) maximum...
-
1125B.3
Clothes rods shall be a maximum of 54 inches (1372 mm) from the floor for a side approach (See Figure 11B-5D). ...
-
Two Step Transfers Attainable Heights
Maximum attainable height difference in two step transfer percentiles (in inches) Percentiles Protocol 5th...
-
Parking
Accessible parking spaces (including access aisles) must be level (maximum slope 1:48 in all directions) and each access aisle must adjoin an accessible route. ...
-
11B-504.4.1 Contrasting stripe
The stripe shall be a minimum of 2 inches (51 mm) wide to a maximum of 4 inches (102 mm) wide placed parallel to, and not more than 1 inch (25 mm) from, the nose of the step or upper approach...
-
E. Chapter 4: Boarding and Alighting
Responses to comments on the Board’s proposal in the 2010 NPRM to revise the technical requirements for the slope of ramps in non-rail vehicles by specifying a single standard (1:6) for maximum...
-
1134A.7, Item 1
The centerline of the water closet shall be 17 inches (432 mm) minimum to 18 inches (457 mm) maximum from a grab bar wall or partition....
-
R404 Clear Spaces (Section-by-Section Analysis)
A 2 percent maximum cross slope is specified for clear spaces. Clear spaces must comply with the technical requirements for surfaces (see R302.7)....
-
Segway Human Transporter
Because both wheels are on one axle, it can turn in place with no turning radius.(19) The Segway HT easily can be governed to travel at various speeds up to a maximum of 12.5 mi/h...
-
Height
The maximum height in ADAAG was used because there was no other objective information available upon which to base a decision on effective height for assisted transfers....
-
Door and Gate Hardware [§404.2.7]
Hardware [§404.2.7] Door and gate hardware must: allow one-hand operation not require tight grasping, pinching, or twisting of the wrist operate with 5 lbf maximum...
