Where provided, keys and controls shall contrast visually from background surfaces....
Search Results "Fire-Building Surface"
Filters
Commonly Searched Documents
-
407.2 Contrast
-
F202.1 General
Additions and alterations to existing buildings or facilities, including leased buildings or facilities, shall comply with F202....
-
§100.201 Entrance
Entrance means any access point to a building or portion of a building used by residents for the purpose of entering....
-
QUESTION: WHAT ACCESSIBILITY STANDARDS APPLY TO PASSENGER RAIL CARS WHEN SPECIFIC DESIGN STANDARDS ARE NOT PROVIDED IN 49 CFR PART 38?
elements of railcars, such as self-service water fountains, ice machines, and condiment dispensers; countertops and dining elements in lounge and bistro cars; and sleeper beds and eating surfaces...
-
BACKGROUND
This applies to 1) alteration or structural repair of an existing building or feature on the site or 2) addition of a new building or new elements to an existing building, facility or site...
-
11B-206.4.8 Service entrances
If a service entrance is the only entrance to a building or to a tenancy in a facility, that entrance shall comply with Section 11B-404....
-
4.1.7(1)(a)
(a) As a general rule, the accessibility provisions of part 4 shall be applied to "qualified" historic buildings and facilities....
-
904.4.1 Parallel Approach
A portion of the counter surface that is 36 inches (915 mm) long minimum and 36 inches (915 mm) high maximum above the finish floor shall be provided....
-
Objectives
The original development work, though targeted toward playground improvements, was eventually seen as a potential improvement for trail surfacing....
-
904.4.1 Parallel Approach
A portion of the counter surface that is 36 inches (915 mm) long minimum and 36 inches (915 mm) high maximum above the finish floor shall be provided....
-
11B-303.5 Warning curbs
Abrupt changes in level exceeding 4 inches (102 mm) in a vertical dimension between walks, sidewalks or other pedestrian ways and adjacent surfaces or features shall be identified by warning...
-
11B-1009.5.4 Transfer steps
The surface of the bottom tread shall extend to a water depth of 18 inches (457 mm) minimum below the stationary water level. Advisory 11B-1009.5.4 Transfer steps....
-
Sesame Retractable Stairs with Lift
The Sesame retracting stairs are the foundation of the Sesame System with the main objective of providing pedestrian and wheelchair access to a building all in one given space....
-
M302.3.1 Transfer Supports (Section-by-Section Analysis)
Based on the restructure of the transfer surface provisions, described above in Section IV.B.1.b....
-
Section 2. Common use areas
"Common use areas" means rooms, spaces or elements inside or outside of a building that are made available for the use of residents of a building or the guests thereof....
-
Transfer Height
Transfer Height Ride seats designed for transfer must be between 14 and 24 inches above the load and unload area surface....
-
R304.5.2 Grade Breaks
Grade breaks shall not be permitted on the surface of ramp runs and turning spaces. Surface slopes that meet at grade breaks shall be flush....
-
11B-406.5.8 Counter slope
Counter slopes of adjoining gutters and road surfaces immediately adjacent to and within 24 inches (610 mm) of the curb ramp shall not be steeper than 1:20....
-
1.1.7.1 Differences
In the event of any differences between these building standards and the standard reference documents, the text of these building standards shall govern....
-
1.1.7.1 Differences
In the event of any differences between these building standards and the standard reference documents, the text of these building standards shall govern....
-
Clear Tread Width and Passing Spaces for Outdoor Recreation Access Routes
Clear tread width means the width of the traveled surface on the ground and also above the ground between obstacles (figure 40)....
-
1012.5 Slope
The slope of the surface of parking spaces and pull-up spaces shall not be steeper than 1:48 in any direction....
-
904.3.2 Counter
The counter surface height shall be 38 inches (965 mm) maximum above the finish floor or ground....
-
5.1.8 Slope
The slope of the surface of the clear ground space shall not be steeper than 1:48 in any direction....
