* indicates data plotted in the graph Figure 3-10. 90-degree turning width: research findings versus the standards....
Search Results "Floor Destination Indicator"
-
3.3.10 90-Degree Turn
-
11B-216.8 Toilet rooms and bathing rooms
Where existing toilet rooms or bathing rooms do not comply with Section 11B-603, directional signs indicating the location of the nearest toilet room or bathing room complying with Section...
-
Visual Alarms
Comments indicated that alarm systems are typically replaced on a 10 - 15 year cycle....
-
Information That May Be Requested in Post-Offer Examinations or Inquiries
An employer may give follow-up tests or examinations where an examination indicates that further information is needed....
-
Performance for Surface Firmness and Stability
Similar to the F1951‒99 lab test, smaller values would indicate less work force necessary to move across the surface, while higher values would indicate greater work force to move across...
-
Definition of "wheelchair.'' (Section-by-Section Analysis)
Many advocacy, nonprofit, and individual commenters indicated that as long as the Department intends the scope of the term ‘‘mobility impairments'' to include other disabilities that cause...
-
Road Roughness Analysis
The literature review also found several approaches that have been used to process the surface roughness measurements into meaningful indices....
-
Definition of "wheelchair." (Section-by-Section Analysis)
Many advocacy, nonprofit, and individual commenters indicated that as long as the Department intends the scope of the term ‘‘mobility impairments'' to include other disabilities that cause...
-
Two-tiered definitional approach. (Section-by-Section Analysis)
In contrast, the vast majority of commenters indicated they were in favor of allowing public entities to conduct an assessment as to whether, and under which circumstances, other power-driven...
-
11B-203.14 Raised diving boards and diving platforms
An accessible route complying with Division 4 shall be provided to the ground- or floor-level entry points, where provided, of stairs, ladders, or other means of reaching the raised elements...
-
3.13(a) Placement of Wheelchair Spaces
Placement of Wheelchair Spaces Each wheelchair space shall comply with the size requirements set forth in § 4.33.2 of the Standards, be level and satisfy the floor surface requirements...
-
1133A.2, Item 2
A clear floor space at least 30 inches (762 mm) by 48 inches (1219 mm) that allows either a parallel or forward approach shall be provided at the kitchen sink and all other fixtures or appliances...
-
1132A.10 Door signal devices
The activating mechanism shall be mounted a maximum of 48 inches (1219 mm) above the floor and connected to permanent wiring....
-
5.8.3.1 Breast Platform Height
The height of the top of the breast platform should be decreased to 26 inches above the floor....
-
11B-608.6 Shower spray unit and water
error by limiting the types of facilities that are allowed to use the vandalism prone area exception and requiring one of the two shower heads to be a maximum of 48 inches above the finish floor...
-
E. Grab Bars
Does each accessible toilet have a horizontal grab bar on the adjacent side wall that is at least 40" long and between 33"-36" above the floor for stabilization and assistance during transfer...
-
F. Grab Bars
Does each accessible toilet have a horizontal grab bar on the wall behind the toilet that is at least 36" long and between 33"-36" above the floor for stabilization and assistance during...
-
308.2.1 Unobstructed
Where a forward reach is unobstructed, the high forward reach shall be 48 inches (1220 mm) maximum and the low forward reach shall be 15 inches (380 mm) minimum above the finish floor or...
-
1132A.4, Item 1
., concrete, brick, flagstone) serving primary entry doors and required exit doors are limited to not more than ½ inch (12.7 mm) of change in height between floor surfaces....
-
306.3.4 Clearance Reduction
Between 9 inches (230 mm) and 27 inches (685 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches...
-
803.5 Coat Hooks and Shelves
Shelves shall be 40 inches (1015 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground....
-
407.12.3.1 Unobstructed Forward Reach
maximum protrusion within the length of the vertical reference plane of the ICT, the operable part shall be 48 inches (1220 mm) high maximum and 15 inches (380 mm) high minimum above the floor...
-
1132A.4, Item 1
., concrete, brick, flagstone) serving primary entry doors and required exit doors are limited to not more than ½ inch (12.7 mm) of change in height between floor surfaces....