Attorney's Office is unable to reach a satisfactory resolution of the issue or issues raised within 30 days of the date it provides notice to Lewisboro, it may institute a civil action in...
Search Results "Maximum Reach Depth"
Filters
Commonly Searched Documents
-
III. IMPLEMENTATION AND ENFORCEMENT
-
VII. APPENDIX: OTHER SOURCES OF INFORMATION
Call 800-669-4000 (voice) or 800-669-6820 (TTY) to reach the field office in your area....
-
Commercial Facilities (Section-By-Section Analysis and Response to Comments)
The phrase, "whose operations affect commerce,'' is to be read broadly, to include all types of activities reached under the commerce clause of the Constitution....
-
NOTES
[and] to a position low enough [19 inches maximum] to allow for the comfort of providers who choose to work in a seated position, to enable patients to keep their feet on the floor while...
-
Clarification on Standard Roll-In Shower Compliance
Since there’s no maximum length for a side wall in a standard roll-in shower, do you think a pull-down grab bar would still be allowed?...
-
[2010 ADAS] 105.2.2 ASME
provisions for escalators require that at least two flat steps be provided at the entrance and exit of every escalator and that steps on escalators be demarcated by yellow lines 2 inches wide maximum...
-
Ramps M303:3.3, 3.3.1, 3.3.2
*The rise of >1 ½ to 2 ½ inches - 1:8 slope is from section 405.2 Maximum Ramp Slope and Rise for Existing Sites, Buildings, and Facilities - [A steeper ramp for a limited rise is allowable...
-
Where must the wheelchair symbol be posted?
trails have been evaluated for accessibility, post the following information in addition to the standard message with the trail name, number, destination, and distance: Typical and maximum...
-
[2010 ADAS] 105.2.2 ASME
provisions for escalators require that at least two flat steps be provided at the entrance and exit of every escalator and that steps on escalators be demarcated by yellow lines 2 inches wide maximum...
-
2. Follow the Accessibility Standards for Play Areas
provided where the restricted accessible route exceeds 30 feet in length; or 2) the clear width of accessible routes shall be permitted to be 36 inches minimum for a distance of 60 inches maximum...
-
Sections 35.108(a)(2) and 36.105(a)(2) Definition of ‘‘disability’’—Rules of Construction
the ADA to require that the definition of ‘‘disability’’ be interpreted in conformance with several specific directives and an overarching mandate to ensure ‘‘broad coverage . . . to the maximum...
-
Section 37.139 Plan Contents
This section and §37.139 provide for a maximum phase-in period of five years, with an assumed one-year phase-in for all paratransit programs....
-
Section 36.211 Maintenance of Accessible Features (Preamble, Section-by-Section Analysis)
The Act requires that, to the maximum extent feasible, facilities must be accessible to, and usable by, individuals with disabilities....
-
Dispersion
In the final rule, the Board has revised the dispersion requirement to allow some overlap (10% maximum) between rooms and to ensure that at least one room provides both wheelchair access...
-
36 CFR Part 1195 Standards for Accessible Medical Diagnostic Equipment - Preamble
The MDE Standards will allow independent entry to, use of, and exit from the equipment by individuals with disabilities to the maximum extent possible....
-
5.8.1.2.1 Ramped Entry Slope Recommendations
The maximum slope for a ramp in the 2010 Standards is a rise of 1 vertical inch for each 12 inches of horizontal distance slope....
-
ADOPTION OF A 19 INCH HEIGHT MINIMIZES COSTS TO HEALTH CARE PROVIDERS
OF A 19 INCH HEIGHT MINIMIZES COSTS TO HEALTH CARE PROVIDERS In the absence of Committee consensus commending a departure from the existing broadly accepted transfer surface height maximum...
-
Introduction
104.1.1 and clarified in its advisory, they are intended to apply only to certain sections of the 2010 ADA Standards where dimensions are stated as single dimensions or as simple minimums or maximums...
-
§35.133 Maintenance of Accessible Features
The Act requires that, to the maximum extent feasible, facilities must be accessible to, and usable by, individuals with disabilities....
-
Protocol A Heights Obtained
The upper 95th percentile transfer heights were 3" higher for the NDVWSC than the HERL group for the maximum height transfer....
-
1. Sloped Surfaces
The maximum running slope generally allowed for ramps is 1:12 (8.33% or 4.76 degrees). Cross slope is the slope or grade of a surface perpendicular to the running slope....
-
232.2.1 Cells with Mobility Features
cells other than those where alterations are originally planned), provided that each substitute cell: (i) is located within the same prison site; (ii) Is integrated with other cells to the maximum...
-
§35.133 Maintenance of accessible features (Section-by-Section Analysis)
The Act requires that, to the maximum extent feasible, facilities must be accessible to, and usable by, individuals with disabilities....
-
1017.4 Passing Spaces
This section requires passing spaces to be provided at intervals of 1000 feet maximum where the clear tread width of trails is less than 60 inches....