Moen Commercial's line of M–DURA™ heavy–duty products are built to last with vandal–resistant features to help reduce your facility's maintenance costs. Ideal for high–traffic...
Search Results "Usable Kitchen (FHA)"
Commonly Searched Documents
- Moen M–Dura Chrome Two-Handle Kitchen Faucet 8225SM
- Moen M–BITION Chrome Two-Handle Kitchen Faucet 8780
- Moen M–Dura Chrome Two-Handle Kitchen Faucet 8229
-
1133A.1 General
Kitchens shall be on an accessible route and shall comply with this section. (See Figure 11A-10A.)...
-
§1193.33 Information, documentation, and training.
[See subsections ...]
-
Section 1193.33 Information, Documentation, and Training (Advisory Guidance)
Section 1193.33 Information, Documentation, and Training
-
When must manufacturers and service providers evaluate access needs?
Manufacturers and service providers must evaluate the accessibility, usability and compatibility of their equipment and services as early and consistently as possible throughout their design...
- Damixa Clover Easy Kitchen Mixer with X-Change Connector Kit 60027
-
4.1 Q. If an owner adds four or more dwelling units to an existing building, are those units covered by the Fair Housing Act?
A. Yes, provided that the units constitute a new addition to the building and not substantial rehabilitation of existing units.
-
9.1 Q. If a building was used previously for a nonresidential purpose, such as a warehouse, office building, or school, and is being converted to a multifamily dwelling, must the building meet the requirements of the Fair Housing Act?
A. No, the Fair Housing Act applies to covered multifamily dwellings for first occupancy after March 13, 1991, and the Fair Housing Act regulation defines first occupancy as a...
-
19.1 Q. If a sliding door track has a threshold of 3/4, does this trigger requirements for ramps?
A. No. The Guidelines at Requirement 4 provide that thresholds at doors, including sliding door tracks, may be no higher than 3/4 and must be beveled with a slope no greater than 1:2.
-
Section 2. Single-story dwelling unit
"Single-story dwelling unit" means a dwelling unit with all finished living space located on one floor.
-
1133A.6 Kitchen sink faucet controls
Faucet controls and operating mechanisms shall be operable with one hand and shall not require tight grasping, pinching or twisting of the wrist. The force required to activate...
-
1133A.6 Kitchen sink faucet controls
Faucet controls and operating mechanisms shall be operable with one hand and shall not require tight grasping, pinching or twisting of the wrist. The force required to activate...
-
5.2 Q. If a building design contains a mix of single-story flats on grade and single-story flats located above grade over a public parking area, do the flats over the parking area have to be accessible?
A. No. In the example in the above question, because some single-story flats are situated on grade, these flats would be the ground floor dwelling units and would be required to be...
-
5.1 Q...Would the first story of single-story dwelling units over the parking level be required to be accessible?
A. Yes. The Guidelines adopt and amplify the definition of ground floor found in HUD's regulation implementing the Fair Housing Act (see 24 CFR 100.201) to indicate that . . .where...
-
6.1 Q...do the dwelling units on both the first and second stories have to be made accessible?
A. Yes. By defining ground floor to be any floor of a building with an accessible entrance on an accessible route, the Fair Housing Act regulations recognize that certain buildings,...
-
§100.205 Design and construction requirements.
[54 FR 3283, Jan. 23, 1989, as amended at 56 FR 11665, Mar. 20, 1991; 73 FR 63616, Oct. 24, 2008]
-
§100.205(e)
(e)
- Kohler® Mazz Single-Handle Pull-Down Sprayer Kitchen Faucet in Vibrant Stainless
-
1133A.4, Item 3
3. Sinks and work surfaces may be a single integral unit a minimum of 60 inches (1524 mm) in length, or be separate components. Exception: Two 15-inch (381 mm) wide minimum...
-
1133A.4.1, Item 1
1. Sinks and work surfaces required by Section 1133A.4 shall be designed to enable repositioning to a minimum height of 28 inches (711 mm).
-
1133A.4.1, Item 1
1. Sinks and work surfaces required by Section 1133A.4 shall be designed to enable repositioning to a minimum height of 28 inches (711 mm).
-
1133A.4.1, Item 4
4. Finished flooring shall be extended to the wall beneath the sink and work surface. Exceptions: 1. Stone, cultured stone and tiled countertops may be used without meeting the...