Model #: 21C142 2-hole 4″ installation Number of handles: 2 With Side Sprayer: No Valve Type: CER-TECK(R) Flow Rate: 1.50 gpm @ 60 psi, 5.7 L/min @ 414 kPa Red/Blue Indicator...
Search Results "Floor Destination Indicator"
Commonly Searched Documents
- Delta Two Handle Centerset Lavatory Faucet 21C142
- Delta Two Handle Blade Bar/Prep Faucet 2171LF-WBHHDF
- Tork Foam Soap Dispenser – with Intuition® Sensor, Stainless Steel
-
Section 37.167 Other Service Requirements
Announcements also must be made at major intersections or destination points. The rule does not define what major intersections or destination points are....
-
Issue: Curb Ramps
Otherwise, these individuals are forced to travel in streets and roadways and are put in danger or are prevented from reaching their destination....
- Bradley Diplomat Soap Dispenser 6A00
- Federal Elevator 360 Passenger Elevator
-
2.2.2 Structural Anthropometry (i.e. Body and WhMD Dimensions)
Key Reference Point Use Floor (defined by multiple reference points) Allows WhMD users to be oriented similarly in 3-D digital space....
-
11B-308.3.2 Obstructed high reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (864 mm) maximum...
-
Notes
II The IDeA Center in its research defined wheelchair wheelbase as the distance from the center of the primary drive wheel to the center of the caster measured parallel to the floor....
-
IV. Program Access
., moving a public information office from the third floor to the first floor of a building....
-
11B-604.7 Dispensers and disposal units
The outlet of the dispenser shall be below the grab bar, 19 inches (483 mm) minimum above the finish floor and shall not be located behind grab bars....
-
11B-803.6 Mirrors
Mirrors shall be installed with the bottom edge of the reflecting surface 20 inches (508 mm) maximum above the finish floor or ground....
-
Problem One (Protruding Objects)
Problem One: Objects, such as branches and ceiling-mounted televisions, over a route are lower than 80 inches above the ground or floor....
-
11B-306.3.4 Clearance reduction
Between 9 inches (229 mm) and 27 inches (686 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches...
-
11B-407.2.1.1 Height
[2010 ADAS] EXCEPTION: Existing call buttons and existing keypads shall be permitted to be located at 54 inches (1370 mm) maximum above the finish floor, measured to the centerline...
-
M301.4 Lift Compatibility
, diagnostic equipment shall not be required to meet the lift compatibility requirements of this section provided that such equipment is clearly labeled as not compatible with portable floor...
-
M302.4 Lift Compatibility
, diagnostic equipment shall not be required to meet the lift compatibility requirements of this section provided that such equipment is clearly labeled as not compatible with portable floor...
-
Basic Features
Careful planning and design will incorporate elements such as a wider entrance door, adequate clear floor space, appropriate placement and models of fixtures and furniture, and grab bars...
-
802.1.4 Approach
Because accessible routes serving wheelchair spaces are not permitted to overlap the clear floor space at wheelchair spaces, access to any wheelchair space cannot be through another wheelchair...
-
5.8.2 Knee and Toe Clearance Under Breast Platform
deep, from the initially proposed 25 inch absolute dimension; increasing the knee clearance directly underneath the breast platform to a minimum of 18 inches; and assuring unobstructed floor...
-
7(2)(a)(i)
Doors may swing into the clear floor space provided at any fixture if the maneuvering space is provided....
-
404.2.7 Door and Gate Hardware
Operable parts of such hardware shall be 34 inches (865 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground....
-
404.2.7 Door and Gate Hardware
Operable parts of such hardware shall be 34 inches (865 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground....