Where vehicle spaces and access aisles are marked with lines, measurements shall be made from the centerline of the markings....
Search Results "Assurances from Contractors"
-
11B-812.1 General
-
(1)(c)
mounted behind the water closet, and a horizontal grab bar at least 40 inches (1015 mm) long should be mounted on at least one side wall, with one end not more than 12 inches (305 mm) from...
-
§ 38.23(b)(8) Platform entrance ramp
The entrance ramp, or loading-edge barrier used as a ramp, shall not exceed a slope of 1:8, measured on level ground, for a maximum rise of 3 inches, and the transition from roadway or sidewalk...
-
1018.2 Aisles in assembly spaces
[DSA-AC] In addition to the requirements of this section, means of egress, which provide access to, or egress from, buildings or facilities where accessibility is required for applications...
-
11B-407.2.2.2 Visible signals
Signals shall be visible from the floor area adjacent to the hall call button. Exceptions: Reserved. Reserved. [2010 ADA Standards] 2....
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
11B-812.1 General
Where vehicle spaces and access aisles are marked with lines, measurements shall be made from the centerline of the markings....
-
1009.3 Stairways
Exception: Exit access stairways providing means of egress from mezzanines are permitted as part of an accessible means of egress....
-
11B-705.1.2.2.2 Parallel curb ramps
Detectable warnings at parallel curb ramps shall be located so the edge nearest the curb is 6 inches (152 mm) minimum and 8 inches (203 mm) maximum from the demarcation line at the face...
-
608.2.1 Transfer Type Shower Compartments
Clearance of 36 inches (915 mm) wide minimum by 48 inches (1220 mm) long minimum measured from the control wall shall be provided....
-
504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
Redi Free® with Redi Base® Shower Pans
Can’t everyone benefit from a barrier free shower entrance? Of course!...
-
Redi Free® with Redi Trench® Shower Pans
Can’t everyone benefit from a barrier free shower entrance? Of course!...
-
The White House Signing Ceremony
She advised White House staff that a celebratory platform should include members of Congress from both parties, Cabinet members, and representatives from major sectors of society....
-
NFPA
a stationary or fixed cooking appliance shall be listed for resistance to common nuisance sources from cooking. 6) Installation near bathrooms....
-
Endorphin 355 Series e4 Resistance System
Pairing an Endorphin cycle with the 355 stand makes the unit functional from a seated or standing position for optimal workout options....
-
E103.4 Defined Terms (Section-by-Section Analysis)
We also propose to delete several definitions from the existing 508 Standards that are either obsolete or no longer needed....
-
4.3.6 Reach Limits
4.3.6 Reach Limits Accommodation models were developed from the research findings for forward and side (lateral) reach in an empty 56 grams (2 oz.) cylinder (figure 4‒8) and a heavier...
-
5. Medical Diagnostic Equipment
From the Board’s website: “The Board has issued accessibility standards for medical diagnostic equipment under section 510 of the Rehabilitation Act....
-
5. Medical Diagnostic Equipment
From the Board’s website: “The Board has issued accessibility standards for medical diagnostic equipment under section 510 of the Rehabilitation Act....
-
302 Floor or Ground Surfaces
Slip-resistance is based on the frictional force necessary to keep a shoe heel or crutch tip from slipping on a walking surface under conditions likely to be found on the surface....
-
Elevator Car Controls
The advisory committee also recommended lowering the maximum height for control buttons from 54 to 48 inches, consistent with its recommendations for reach ranges generally....
-
Shower Spray Unit
Comments from persons with disabilities strongly supported the requirement for the on/off control....
-
1117B.5.3
Characters on signs shall be selected from fonts that have a width-to-height ratio of between 3:5 (60 percent) and 1:1 (100 percent) measured by the width of the uppercase letter "O" and...
