Common Requirements (R304.5) (Section-by-Section Analysis) The clear width of curb ramp runs (excluding flared sides), blended transitions, and turning spaces must be 1.2 meters (4 feet...
Search Results "Water Closet Clear Floor Space"
-
Common Requirements (R304.5) (Section-by-Section Analysis)
-
11B-302.2 Carpet
Exposed edges of carpet shall be fastened to floor surfaces and shall have trim on the entire length of the exposed edge....
-
11B-216.5 Parking and electric vehicle charging facilities
Signs identifying parking spaces and signs within parking facilities shall comply with Section 11B-216.5....
-
Model Building Codes and Industry Standards
For example, unlike the ADA guidelines, the ANSI standards require an additional vertical grab bar at water closets, transfer shower stalls, and tubs....
-
11B-407.4.6.1 Location
Exceptions: Where the elevator panel serves more than 16 openings and a parallel approach is provided, buttons with floor designations shall be permitted to be 54 inches (1372 mm)...
-
Catch Pool
A pool or designated section of a pool used as a terminus for water slide flumes....
-
4.10.12(3)
All floor buttons shall be no higher than 54 in (1370 mm) above the finish floor for side approach and 48 in (1220 mm) for front approach....
-
American Standard Yorkville 1.1 gpf FloWise Right Height Elongated Pressure Assisted Toilet
-
Neo-Metro Urban Stainless Steel Toilet 8950-3-ADA-PFS Model
Requires the Premium User plan or above. (Login or upgrade your account!) -
1009.7.1 Size
Each exterior area for assisted rescue shall be sized to accommodate wheelchair spaces in accordance with Section 1009.6.3....
-
Mezzanine
An intermediate level or levels between the floor and ceiling of any story with an aggregate floor area of not more than one-third of the area of the room or space in which the level or...
-
11B-812.7.1 Location
Access aisles at vehicle spaces shall not overlap the vehicular way and may be placed on either side of the vehicle space they serve except for van accessible spaces which shall have access...
-
Just Manufacturing Deck Mounted Classroom Faucet with Vandal Resistant Lever Handle
Lever handle is chrome plated die cast(vandel resistant) Equipped with water saving aerator. Vandel resistant pin in base prevents turning....
-
11B-502.7.2 Wheel stops
A curb or wheel stop shall be provided if required to prevent encroachment of vehicles over the required clear width of adjacent accessible routes....
-
R406.3 Unobstructed Side Reach
Where a clear space allows a parallel approach to an element and the side reach is unobstructed, the high side reach shall be 1220 mm (4.0 ft) maximum and the low side reach shall be 380...
-
11B-308.3.2 Obstructed high reach
Where a clear floor or ground space allows a parallel approach to an element and the high side reach is over an obstruction, the height of the obstruction shall be 34 inches (864 mm) maximum...
-
11B-407.4.6.1 Location
Where the elevator panel serves more than 16 openings and a parallel approach is provided, buttons with floor designations shall be permitted to be 54 inches (1372 mm) maximum above the...
-
407.4.6.1 Location
Where the elevator panel serves more than 16 openings and a parallel approach is provided, buttons with floor designations shall be permitted to be 54 inches (1370 mm) maximum above the...
-
Check-Out Aisles [7.3]
Clear passage must be at least 36 inches wide continuously and 32 inches at a point (24 inch maximum distance). Access can be provided at aisles shared between two check-outs....
-
Caroma® USA Sydney Low Profile 270 Easy Height Round Front Plus Toilet Front Elevation
Requires the Premium User plan or above. (Login or upgrade your account!) -
11B-206.3 Location
An accessible route shall not pass through kitchens, storage rooms, restrooms, closets or other spaces used for similar purposes, except as permitted by Chapter 10. U.S....
-
11B-809.9.3 Removable base cabinets
Knee and toe space complying with Section 11B-306 shall be provided at sinks and work surfaces required to comply with Section 11B-809.9.4....
-
11B-411.4.11.1 Height
Floor destination characters shall be 1 inch (25 mm) high minimum complying with Section 11B-703.5.3....