New Construction ADA requirements for new construction have been in effect since January 1992....
Search Results "Supplemental Requirement"
-
New Construction
-
T201 General
Buses, OTRBs, and vans acquired or remanufactured by entities covered by the ADA must comply with the scoping requirements in Chapter 2 to the extent required by DOT’s implementing regulations...
-
401.1 Scope (Section-by-Section Analysis)
401.1 Scope (Section-by-Section Analysis) This section proposes that the technical requirements for hardware in Chapter 4 be applied where (a) required by 508 Chapter 2 or 255 Chapter...
-
Beach Access Routes
The proposed rule would have required beach access routes to be provided where a beach is constructed and where a pedestrian route is constructed at a beach....
-
Calculation of Percentages
Rounding up to the next greater whole number is required where fractions or remainders occur....
-
1133A.4.1 Repositionable countertops
Base cabinets directly under sinks and work surfaces shall be removable as required in Section 1133A.3....
-
402.2 Components
All components of an accessible route shall comply with the applicable requirements of Chapter 4 and 208.3.1. Advisory 402.2 Components....
-
203.9 Employee Work Areas
Spaces and elements within employee work areas shall only be required to comply with 206.2.8, 207.1, and 215.3 and shall be designed and constructed so that individuals with disabilities...
-
224.1.1 Alterations
Where guest rooms are altered or added, the requirements of 224 shall apply only to the guest rooms being altered or added until the number of guest rooms complies with the minimum number...
-
604.8.1.7 Water closet
., stipulates that “…required bathing rooms and toilet rooms in new construction shall be designed and constructed…” with an accessible lavatory in the wheelchair accessible compartment...
- Ampetronic MLD7 MultiLoop Driver Hearing System
- Ampetronic MLD5 MultiLoop Driver Hearing System
-
F201.3 Temporary and Permanent Structures
These requirements shall apply to temporary and permanent buildings and facilities. Advisory F201.3 Temporary and Permanent Structures....
-
Launch Ramps Without Boarding Piers
The Department of Justice advises that if there are no applicable scoping requirements (i.e., how many features must be accessible), then a reasonable number, but at least one, must be accessible...
-
What this Checklist is Not
What this Checklist is Not The ADA title II and III regulations require more than program accessibility and barrier removal....
-
§ 36.501(b) Injunctive relief
36.405 of this part, injunctive relief shall include an order to alter facilities to make such facilities readily accessible to and usable by individuals with disabilities to the extent required...
-
201.3 Temporary and Permanent Structures
These requirements shall apply to temporary and permanent buildings and facilities. Advisory 201.3 Temporary and Permanent Structures....
-
11B-230.1 General
This requirement applies to facilities such as office buildings, courthouses, and other facilities where admittance to the building or restricted spaces is dependent on two-way communication...
-
11B-407.2.2.1 Visible and audible signals
In existing elevators, a signal indicating the direction of car travel shall not be required....
-
11B-107 Special conditions appeals action
Due diligence is advised whenever an appeal is made in lieu of strict compliance with stated scoping and/or technical requirements....
-
11B-107 Special conditions appeals action
Due diligence is advised whenever an appeal is made in lieu of strict compliance with stated scoping and/or technical requirements....
-
11B-1008.3.2.3 Transfer supports
Transfer supports are required on transfer platforms and transfer steps to assist children when transferring....
-
11B-704.5 TTY shelf
Public pay telephones required to accommodate portable TTYs shall be equipped with a shelf and an electrical outlet within or adjacent to the telephone enclosure....
-
11B-703.7.2.6.2 Women’s toilet and bathing facilities
Exception: Within secure perimeter of detention and correctional facilities, geometric symbols shall not be required to be ¼ inch (6.4 mm) thick....