Each exit door through a horizontal exit that is required to comply with Section 1011.1 shall be identified by a sign with the words, “TO EXIT.”...
Search Results "Door Maneuvering Clearance"
Filters
Commonly Searched Documents
-
1011.4, Item 5
-
Toilet Compartments: ADA Standard Section 213.3.1
Section 213.3.1 covers scoping requirements in the current ADA Standards for toilet compartments.
-
Bobrick ConturaSeries Surface-Mounted Seat-Cover Dispenser B-4221
Allow 5" (125mm) minimum clearance from bottom of dispenser to top of any horizontal projection for filling dispenser from below unit....
-
Bobrick Recessed Paper Towel Dispenser B-318
Rough Wall Opening: 12" W, 18 1⁄4" H (305 x 465mm) to accept cabinet height, plus 6" (150mm) min. clearance space below towel tray; 4 1⁄2" (115mm) min. depth....
-
Free-Standing Overhead Lifts
An overhead lift does not require the additional maneuvering space needed by a portable floor lift....
-
9. Exterior Ramps
...do the exterior ramps have the following features: a. top and bottom landings that are level, at least as wide as the ramp they serve, and at least 60" long to allow for adequate maneuvering...
-
M. Single-User or "Family" Toilet Room
These features include an accessible entrance and turning and maneuvering spaces....
-
4.4.1* GENERAL
Protruding objects shall not reduce the clear width of an accessible route or maneuvering space (see Fig. 8(e)). Figure 8 Protruding Objects...
-
Obstructions [4.7.8]
Space is needed at the top and bottom of ramps so that people using wheelchairs can align with the running slope and maneuver from ramps, including when making turns (which is difficult...
-
Builders Hardware Manufacturers Association (BHMA)
Together these companies produce the vast majority of the hardware items used in the nation’s commercial and institutional buildings -- from hinges and locks to door controls and exit devices...
-
1h
Are the accessible small showers free of doors that would impede wheelchair transfer to the seat?...
-
7. Seat Transfer
Are the roll-in showers free of doors that would impede wheelchair transfer onto the seat? [ADA Stds. 4.21.8] Yes __ No __ N/A __ Comments: _______________________________________...
-
Element
., telephone, curb ramp, door, drinking fountain, seating, or water closet....
-
ELEMENT
., telephone, curb ramp, door, drinking fountain, seating, water closet....
-
5. Accessible Features
interior routes; snow removal on exterior routes; replacing damaged or stolen room identification signs; tightening or adjusting accessible toilet seat fasteners, grab bars, handrails and door...
-
704.5 TTY Shelf
The shelf shall be capable of accommodating a TTY and shall have 6 inches (150 mm) minimum vertical clearance above the area where the TTY is to be placed....
-
4.2.6* SIDE REACH
If the side reach is over an obstruction, the reach and clearances shall be as shown in Fig. 6(c). Figure 6 Side Reach...
-
Murdock Manufacturing Grab Bars
Grab bar is 1-1/2 inch (3.81 cm) diameter satin finish stainless steel and have 1-1/2 inch (3.81 cm) clearance to wall....
-
1009.9 Signage
Each door providing access to an area of refuge from an adjacent floor area shall be identified by a sign stating: AREA OF REFUGE. 2....
-
§ 38.175(a)
The design of cars shall be coordinated with the boarding platform design such that the horizontal gap between a car door at rest and the platform shall be no greater than 3 inches and the...
-
Oven Controls
A specification that these controls be to the side of the door has been removed in the final rule as unnecessarily restrictive....
-
Question 17
Are the signs for the accessible restrooms and fitting rooms still readable and mounted next to the latch side of the door, at 5 feet to centerline of the sign?...
-
11B-611.3 Operable parts
Operable parts, including doors, lint screens, and detergent and bleach compartments shall comply with Section 11B-309....
-
If a more recent edition of ANSI/BHMA Standards for automated doors is issued should that be followed instead of those referenced?
The specific editions of the ANSI/BHMA Standards referenced by the Standards are to be followed (although the Access Board intends to update references to keep them current)....
