Compliance costs for federal agencies are classified as either one-time or annual, and are assessed based on various fixed percentages of baseline costs depending on the nature of the cost...
Search Results "Fixed Assembly Seating"
-
2. General Framework of Assessment
-
Section 37.139 Plan Contents
Section 37.139 Plan Contents This section contains substantive categories of information to be contained in the paratransit plan: Information on current and changing fixed route service...
-
382.13 Do carriers have to modify policies, practices, and facilities to ensure nondiscrimination?
One difference is that the new rule specifies that carriers may require preboarding as a condition of receiving certain seating or in-cabin stowage accommodations....
-
§382.43(c)
(c) If you are a U.S. or foreign air carrier that operates at least one aircraft having a designed seating capacity of more than 60 passengers and owns or controls a primary Web site that...
-
§382.157(c)
following areas: refusal to board, refusal to board without an attendant, security issues concerning disability, aircraft not accessible, airport not accessible, advance notice dispute, seating...
-
REDUCTION OF ACCESSIBLE ELEMENTS
EXAMPLE Under the 1991 ADA Standards, a theater with 5,000 seats was required to have 51 wheelchair accessible locations....
-
M301.3.3 Head and Back Support
Head and Back Support Proposed requirement: Where diagnostic equipment used by patients in a supine, prone, or side-lying position, and diagnostic equipment used by patients in a seated...
-
§ 382.43(c)
(c) If you are a U.S. or foreign air carrier that operates at least one aircraft having a designed seating capacity of more than 60 passengers and owns or controls a primary Web site that...
-
Tandem Bicycles
Most tandem bicycles are similar to upright single bikes where riders sit on a small saddle and reach forward to handlebars that are typically at or slightly above or below the seat height...
-
4.21.2 Size and Clearances
To this end, several projects incorporated a half height wall to enable a caregiver using a hand held shower to stay dry while standing behind a resident seated in a shower chair....
-
4.20.2 Floor Space
The amount of clear floor space in front of a bathtub required by ADAAG (30"-48" min depth depending on the direction of travel by the length of the tub including a seat at the head of the...
-
Stirrups (M301.3.2)
b) Should diagnostic equipment used by patients in a seated position that provide stirrups such as urodynamics study chairs be required to provide a method of supporting, positioning, and...
-
Grab Bar and Backrest Evaluation
The analysis also revealed that the presence of grab bars helped participants to transfer higher and lower than their mobility device seats....
-
Equivalent Facilitation [§103]
For example, transfer shower stalls are required to be 36 inches by 36 inches absolute so that grab bars remain within reach from the seat....
- HEWI Washbasins
- TechnoGym® - Radiant Inclusive Commercial Fitness System
- AJW Architectural Products U109 16 oz. Plastic Bulb Liquid Soap Dispenser - Surface Mounted
- Delta Single Handle Pull-Down Kitchen Faucet 9158-SB-DST
- Whitehall Mfg. 3374-WSF Hot & Cold Hemispherical Widespread Pushbuttons Pneumatic Valve Conical Faucet
- Landscape Forms Inc. FGP Trash Receptacle
-
ASME
This document does not permit the use of inclined stairway chairlifts which do not provide platforms because such lifts require the user to transfer to a seat....
-
Applicable standards. (Section-by-Section Analysis)
regulatory provisions are necessary to clarify how the Department will apply the 2010 Standards to places of lodging, social service center establishments, housing at a place of education, assembly...
-
Applicable standards
regulatory provisions are necessary to clarify how the Department will apply the 2010 Standards to places of lodging, social service center establishments, housing at a place of education, assembly...
-
4.1.3(5)*
this guideline and applicable state or local codes may be used in lieu of an elevator only under the following conditions: (a) To provide an accessible route to a performing area in an assembly...