[2010 ADA Standards] 703.4.1 Height Above Finish Floor or Ground....
Search Results "Standards Development"
-
11B-703.4.1 Height above finish floor or ground
-
11B-407.3.4 Door and signal timing
[2010 ADA Standards] 2. Destination-oriented elevators shall not be required to comply with 407.3.4....
-
11B-206.4.1 Entrances
[2010 ADA Standards] 206.4.1 Public Entrances....
-
11B-806.2.3.1 Personal lift device floor space
ETA Editor's Note The clearance prescribed for a personal lift device at CBC 11B-806.2.3.1 is not required by 2010 ADA Standards....
-
11B-607.2 Clearance
[2010 ADA Standards] 607.2 Clearance. Clearance in front of bathtubs shall extend the length of the bathtub and shall be 30 inches (760 mm) wide minimum....
-
11B-703.4.1 Height above finish floor or ground
[2010 ADA Standards] 703.4.1 Height Above Finish Floor or Ground....
-
11B-806.3 Guest rooms with communication features
For headset or external amplification system compatibility, a standard subminiature jack installed in the telephone will provide the most flexibility. ◼...
-
11B-407.3.4 Door and signal timing
[2010 ADA Standards] 2. Destination-oriented elevators shall not be required to comply with 407.3.4....
-
406.2.2 Clear height
While the minimum height is required to be 7'-0" by this section, greater vertical clearance is required at van-accessible parking spaces, standard accessible parking spaces, the vehicular...
-
11B-705.1.1.2 Dome spacing
[2010 ADA Standards] 705.1.2 Dome Spacing....
-
11B-810.2.2 Dimensions
Access Board's Note to Reader: The Department of Transportation's ADA Standards indicate that compliance is required to the extent construction specifications are within a public entity's...
-
Final Regulatory Impact Analysis
The Final RIA embodies a comprehensive benefit-cost analysis of the final rules for both title II and title III and assesses the incremental benefits and costs of the 2010 Standards relative...
-
Section 36.103 Relationship to Other Laws (Section-By-Section Analysis and Response to Comments)
Paragraph (a) provides that, except as otherwise specifically provided by this part, the ADA is not intended to apply lesser standards than are required under title V of the Rehabilitation...
-
Organization of This Rule
Throughout this rule, the original ADA Standards, which are republished as Appendix D to 28 CFR part 36, will be referred to as the ‘‘1991 Standards.''...
-
Appendix: Revised Annotated Bibliography
standard techniques....
-
11B-407.4.1 Car dimensions
[2010 ADA Standards] EXCEPTION: Existing elevator car configurations that provide a clear floor area of 16 square feet (1.5 m2) minimum and also provide an inside clear depth 54 inches...
-
11B-502.3.3 Marking
[2010 ADA Standards] 502.3.3 Marking. Access aisles shall be marked so as to discourage parking in them. Advisory 11B-502.3.3 Marking....
-
11B-219.3 Receivers
[2010 ADA Standards] 219.3 Receivers. Receivers complying with 706.2 shall be provided for assistive listening systems in each assembly area in accordance with Table 219.3....
-
11B-407.4.1 Car dimensions
[2010 ADA Standards] EXCEPTION: Existing elevator car configurations that provide a clear floor area of 16 square feet (1.5 m2) minimum and also provide an inside clear depth 54 inches...
-
11B-502.3.3 Marking
[2010 ADA Standards] 502.3.3 Marking. Access aisles shall be marked so as to discourage parking in them. Advisory 11B-502.3.3 Marking....
-
11B-219.3 Receivers
[2010 ADA Standards] 219.3 Receivers. Receivers complying with 706.2 shall be provided for assistive listening systems in each assembly area in accordance with Table 219.3....
-
Introduction
The Manual is designed to be updated periodically with supplements as the Commission develops further policy guidance and identifies additional resources....
-
Wheelchairs and Other Power-Driven Mobility Devices
indoors or outdoors, its placement of stationery equipment or devices or furniture, and whether it has storage space for the device if requested by the customer; Whether legitimate safety standards...
-
5.1.1 Transfer Surface Height Adjustability Recommendation for M301 and M302
Thus, the committee adopted a standard of adjustability in small, virtually infinite increments....