Commenters noted that the 2010 Standards will require handrail gripping surfaces with a circular cross section to have an outside diameter of 2 inches, and that this requirement would impose...
Search Results "Surface Smoothness"
Filters
Commonly Searched Documents
-
Sections 505.10.2 and 505.10.3
-
Q5: Effective Date for Public Entities to Comply
This technical assistance was provided to respond to questions that arose largely due to the development of a variety of road surface treatments, other than traditional road resurfacing,...
-
G. What are Detectable Warnings, Why are They Required, and Where Must They be Provided?
They must be integrated into the walking surface, and there are specific measurements for the size and spacing of the domes.13 What is the function of detectable warnings?...
-
604.7 Dispensers
paper dispensers are installed above the side wall grab bar, the outlet of the toilet paper dispenser must be 48 inches (1220 mm) maximum above the finish floor and the top of the gripping surface...
-
Baby Changing Tables
In addition, convenience fixtures, such as baby changing tables, must be accessible to persons with disabilities under scoping provisions for operable parts (205) and work surfaces (226)...
-
M303.2.2 Width (Section-by-Section Analysis)
an exception in the final rule that permits wheelchair spaces on raised platforms to be 32 inches wide minimum with edge protection no higher than 4 inches, measured from the platform surface...
-
1127B.5, Item 4
A level landing 4 feet (1219 mm) deep shall be provided at the upper end of each curb ramp over its full width to permit safe egress from the ramp surface, or the slope of the fanned or...
-
Technical Memorandum TM 2013-22 Storage (Kitchens and Kitchenettes)
Counter surfaces shall not be considered shelf space nor used to satisfy the requirements of 804.5....
-
1017.4 Passing Spaces
at shorter intervals if the clear tread width is less than 60 inches (1525 mm), where a trail is: --Heavily used; or --A boardwalk or otherwise not at the same level as the ground surface...
-
5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms
5.8.1.2 Entry to Wheelchair Spaces on Raised Platforms Recommendations Description: Entry to wheelchair spaces on raised surfaces greater than ¼ inch in height requires a transition...
-
CONTENTS
Increasing number of Health Care Providers are Transitioning to Adjustable Height Tables Available data do not support departing from the currently accepted standard of 19-Inch transfer surface...
-
Implementation Challenges for Interiors (slides 16 and 17)
In the past, [we] have been required to have truncated cones covering the entire surface. For someone in a wheelchair, that is literally hell....
-
Disorienting Spaces (slide 7)
It’s actually a flat surface, and then going into the lovely, also very easy-to-navigate checkerboard flooring pattern....
-
Protruding Objects on Beach Access Routes
as signs that extend into the clear width area of a beach access route or resting interval and are between 27 inches (685 millimeters) and 80 inches (2,030 millimeters) above the travel surface...
-
1017.4 Passing Spaces
at shorter intervals if the clear tread width is less than 60 inches (1525 mm), where a trail is: • Heavily used; or • A boardwalk or otherwise not at the same level as the ground surface...
-
Beach Access Routes
Beach access routes provide a firm and stable surface over the sand and are used by beach visitors with and without disabilities....
-
Construction Specification Institute
Construction Specification Institute While developing suggested tolerances for surface materials, the Construction Specifications Institute developed a suggested method for measuring ramp...
-
1.1.1
The simplest way for design professionals to avoid problems with construction tolerances related to surface accessibility and other accessible elements is to design for slopes and dimensions...
-
Other Sources
The Access Board used anthropometric data and other standards for the width of transfer surfaces on diagnostic equipment used by patients in a seated position (see M302.2.2), height of breast...
-
11B-703.7.2.6.3 Unisex toilet and bathing facilities
The color of the circle symbol shall contrast with the color of the door or surface on which the combined circle and triangle symbol is mounted, either light on a dark background or dark...
-
11B-703.7.2.6 Toilet and bathing facilities geometric symbols
Geometric symbols at entrances to toilet and bathing rooms shall be mounted at 58 inches (1473 mm) minimum and 60 inches (1524 mm) maximum above the finish floor or ground surface measured...
-
11B-1008.2.3 Water play components
Exceptions: Where the surface of the accessible route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with Sections 11B-302,...
-
Bradley 3-Station Express Lavatory System SS-3N
, ANSI, UFAS and TAS Compliant Serves 1 - 3 users at a time Standard lavatory spacing on 30" centers Continuous bowl is constructed of vandal-resistant Terreon or TerreonRE Solid Surface...
-
Bradley 2-Station Express Lavatory System SS-2N
, ANSI, UFAS and TAS compliant Serves 1 - 2 users at a time Standard lavatory spacing on 30" centers Continuous bowl is constructed of vandal-resistant Terreon or TerreonRE Solid Surface...
