The APS shown in Figure 13 are appropriately located within the landscape strip, reachable from a paved level surface, and aligned with the crosswalk lines....
Search Results "Reflecting Surface"
Commonly Searched Documents
-
Issue 9: Reach (how far?)
-
Q3.) What are the types of “manufacturing processes” that were anticipated where the advisory says “tolerances recognized by this provision include… “those that may be a necessary consequence of a particular manufacturing process”?
Similarly, the surfaces of ceramic tiles that form the wall behind a grab bar will not be perfectly flat due the manufacturing processes that make them. ...
-
Seats
The deck surface between the centerline of the seat and the pool edge cannot have a slope greater than 1:48....
-
R105 Definitions (Section-by-Section Analysis)
ramp, element, facility, grade break, operable part, pedestrian access route, pedestrian circulation path, public right-of-way, qualified historic facility, running slope, and vertical surface...
-
Supporting Documents for the Medical Diagnostic Equipment Accessibility Standards Advisory Committee Report
Chairs Subcommittee Report - Imaging Equipment Subcommittee Report - Mammography Subcommittee Report - Stretchers Subcommittee Report - Weight Scales IDeA Center Memo – Transfer Surface...
-
FEATURES
Beds, stretchers, and other types of equipment will have unique features that determine the shapes of their patient support surfaces....
-
1009.4.5 Grab Bars
The top of the gripping surface shall be 4 inches (100 mm) minimum and 6 inches (150 mm) maximum above transfer walls....
-
11B-1009.4.5 Grab bars
The top of the gripping surface shall be 4 inches (102 mm) minimum and 6 inches (152 mm) maximum above transfer walls....
-
Edge Protection
Recommendation: At narrow routes in particular, consider maintenance of adjacent surfaces as raised or flush or wider route widths in consideration of minimum maneuvering and passage requirements...
-
Landings [4.8.4]
It is recommended that landings of exterior ramps be drained so that water does not accumulate on the surface....
-
C. Defendants' Transaction Counter
But “[b]ecause of the cash registers and merchandise displays . . . defendant does not provide a 36-inch-long clear counter surface.” Id....
-
Stairs
At the top, the extension shall be parallel with the floor or ground surface....
- Inpro ENDURANT® Shower Receptors
- Wikk Industries Inc. Bollard With Push Plate PART#BPR SM AINS 32D (630)
-
Public Postsecondary Schools
and administered so as best to ensure that, when a test is administered to an applicant who has a handicap that impairs sensory, manual, or speaking skills, the test results accurately reflect...
-
EXECUTIVE SUMMARY
(The STI is, in effect, a measure of reverberation and noise upon the integrity of the speech source; numbers lower than 1.0 reflect degrees of degradation of the originating signal)....
- Spinal Cord Injury Association of Washington (SCIAW)
-
Wheelchair Spaces
Wheelchair spaces may be placed side-by-side, as reflected in specifications for width that are specific to adjoining spaces....
-
Section 36.403 Alterations: Path of Travel
a private entity has constructed or altered required elements of a path of travel in accordance with the 1991 Standards, the private entity is not required to retrofit such elements to reflect...
-
Issue: Curb Ramps
Milestones should occur on a regular basis throughout the course of the transition plan and must reflect a priority to walkways serving government buildings and facilities, bus stops and...
-
‘‘Private club.’’ (Preamble, Section-by-Section Analysis)
The rule, therefore, as reflected in § 36.102(e) of the application section, limits the coverage of private clubs accordingly....
-
Private club (Section-By-Section Analysis and Response to Comments)
The rule, therefore, as reflected in Sec.36.102(e) of the application section, limits the coverage of private clubs accordingly....
-
Section 37.7 Standards for Accessible Vehicles
The entity must consult with the public through some means of public participation in devising its alternative form of compliance, and the public input must be reflected in the submission...