The minimum vertical clearance at designated passenger drop-off and loading zones, and along at least one vehicle access route to the area from site entrances and exits, is 114 inches....
Search Results "ASID: American Society of Interior Designers"
Commonly Searched Documents
-
11B-503.5 Vertical clearance
-
Standards and Anthropometry for Wheeled Mobility
ACCESS BOARD, WASHINGTON, DC Authors: Edward Steinfeld, Jordana Maisel, Dave Feathers July, 2005 Center for Inclusive Design and Environmental Access (IDEA) School of Architecture...
- Cornelius, Inc. FlavorFusion Ice Drink Dispenser
- Harris Communications Inc. ADA Compliant Guest Room Kit 500A Hard Case
- Elkay Wall Mount Bi-Level ADA Water Cooler EZSTL8LC
-
Clear Width of Circulation Paths and Maneuvering Clearances at Wheelchair Spaces
Manufacturers also noted concerns about design constraints due to current axle designs, noise level specifications, and wheel well strength requirements....
-
ADMINISTRATIVE AUTHORITY
[DSA-AC] A governmental agency that adopts or enforces regulations and guidelines for the design, construction, or alteration of buildings and facilities....
-
§382.151(a)
(a) As a carrier providing service using aircraft with 19 or more passenger seats, you must designate one or more CROs....
-
M101.4 Equivalent Facilitation
The use of alternative designs or technologies that result in substantially equivalent or greater accessibility and usability than specified in the MDE Standards is permitted....
-
T404.2 Vehicle Floor and Boarding Platform Coordination
The design of non-rail vehicles shall be coordinated with the boarding platforms to minimize the gap between the vehicle floor and the boarding platforms....
-
4(2)(b)
(b) Design features such as sunken or raised functional areas do not interrupt the accessible route through the remainder of the dwelling unit....
-
§ 35.152(b)(2)(ii)
(ii) Should not place inmates or detainees with disabilities in designated medical areas unless they are actually receiving medical care or treatment;...
-
4.24.7 Faucets
Lever-operated, push-type, touch-type, or electronically controlled mechanisms are acceptable designs....
-
9.4 Other Sleeping Rooms and Suites
Doors and doorways designed to allow passage into and within all sleeping units or other covered units shall comply with 4.13.5....
-
4.34.3 ADAPTABILITY
Accessible dwelling units may be designed for either permanent accessibility or adaptability....
-
Depth
The design allowed one to reach inside through the columns to some degree....
-
4.24.7 FAUCETS
Lever-operated, push-type, touch-type, or electronically controlled mechanisms are acceptable designs....
-
Vehicle Parking Lot
An area specifically intended for parking of more than two motor vehicles, usually divided into multiple designated parking spaces. ...
-
§100.205(e)(2)
(2) The following also qualify as HUD-recognized safe harbors for compliance with the Fair Housing Act design and construction requirements:...
-
BOAT LAUNCH RAMP
[DSA-AC] A sloped surface designed for launching and retrieving trailered boats and other water craft to and from a body of water....
-
2010 Standards
2010 Standards means the 2010 ADA Standards for Accessible Design, which consist of the 2004 ADAAG and the requirements contained in §35.151....
-
§ 35.152(b)(2)(ii)
(ii) Shall not place inmates or detainees with disabilities in designated medical areas unless they are actually receiving medical care or treatment;...
-
§ 37.5(c)
(c) An entity shall not require an individual with a disability to use designated priority seats, if the individual does not choose to use these seats....
-
PERMANENT
[DSA-AC] Facilities which, are intended to be used for periods longer than those designated in this code under the definition of “Temporary.”...