DAS Trainings: Introduction to ADA/FEHA Practical Solutions to Reasonable Accommodation Principles of Accessible Documents Creating Accessible Forms...
Search Results "Support Documentation"
- State of California Disability Access Services (DAS) - Information Links: Resources, Service Animals & Etiquette
-
M305.2.3 Height
During use, the tops of transfer support gripping surfaces shall be 6 inches (150 mm) minimum and 19 inches (485 mm) maximum higher than the top of the associated uncompressed transfer surface...
-
M305.2.5 Surface Hazards (Section-by-Section Analysis)
The proposed rule did not provide any specific restrictions regarding surface hazards around the transfer supports....
-
(1) Transfer Surface Location for Diagnostic Equipment Used in the Supine, Prone, or Side-lying Position
This revision to provide options for two types of transfer surfaces necessitated adding additional technical criteria addressing transfer surface size (M301.2.3) and transfer supports (M305.2...
-
M305.2.4.1 Circular Cross Section
Transfer supports with circular cross sections shall have an outside diameter of 1 ¼ inches (32 mm) minimum and 2 inches (51 mm) maximum....
-
Examples of access:
Exam table that lowers to 17-19 inches from the floor Many people find these tables easier to use. There are many ways to help people get access. See the [images]...
-
ADA Requirements - Service Animals
U.S. Department of Justice Civil Rights Division Disability Rights Section Service Animals The Department of Justice published revised final regulations implementing the...
-
CHAPTER 6: SUPPORT DOCUMENTATION AND SERVICES
[See subsections ...]
-
M305.2.4.2 Non-Circular Cross Section
Transfer supports with non-circular cross sections shall have a cross-section dimension of 2 inches (51 mm) maximum and a perimeter dimension of 4 inches (100 mm) minimum and 4.8 inches...
-
Document Formats
This document is available in the following formats for persons with disabilities -- Braille Large print Audiocassette Electronic file on computer disk and...
- Big John Toilet Support & Short Swivel Support
-
d. Unobstructed Transfer
Six of the eleven commenters who responded to this question supported permitting equipment parts to extend up to three inches horizontally beyond the edge of the transfer surface....
-
Sample Documents
Editor's Note The following link points to the documents referenced above: http://www.adaactionguide.org/resources#sampledocuments Grievance Procedure - long and short versions...
-
E202.6.1 Required Documentation (Section-by-Section Analysis)
E202.6.1 Required Documentation (Section-by-Section Analysis) This section proposes to require that agencies document in writing the basis for determining that ICT fully conforming to...
- Big John Toilet Support & Short Swivel Support informational video
- Big John Toilet Support & Short Swivel Support 7.5" to 14" Installation Video
-
Independent Wheelchair Transfers in the Built Environment: How Transfer Setup Impacts Performance Phase 2: Final Report
herl.pitt.edu/ab/ DISCLAIMER This study was conducted by the Human Engineering Research Laboratories (HERL) from the University of Pittsburgh and VA Pittsburgh Health Care System with support...
-
The Impact of Transfer Setup on the Performance of Independent Transfers: Phase I Final Report
herl.pitt.edu/ab/ DISCLAIMER This study was conducted by the Human Engineering Research Laboratories (HERL) from the University of Pittsburgh and VA Pittsburgh Health Care System with support...
- Grammar Support in Proloquo2Go 4
-
Standing Supports [M305.2]
Standing Supports [M305.2] Recommendation: The final recommendation of the subcommittee is to remove the requirement for standing supports in reference to mammography equipment....
-
9. Broadening of Documentation Requirement for Undue Burden Exception
Section 1194.2 (a)(2) of the existing 508 Standards requires agencies to provide supporting documentation when determining that procurement of a compliant product would impose an undue burden...
-
E202.5.2 Required Documentation
The responsible agency official shall document in writing the basis for determining that conformance to requirements in the 508 Standards constitute an undue burden on the agency, or would...
-
6. DOCUMENTATION
In addition, if a determination is made that a facility is not subject to these DoD Standards, the DoD Component Head must ensure that documentation is maintained to justify the determination...
-
E202.6.2 Required Documentation
The responsible agency official shall document in writing the basis for determining that conformance to requirements in the Revised 508 Standards constitute an undue burden on the agency...
