Transfer Surface Size Recommendations for Stretchers (M301) The Committee recommends a minimum transfer surface size of 28 inches wide by 17 inches deep for stretchers located on both long sides...
Search Results "Side Entry"
Commonly Searched Documents
- 
    
  
  5.2.1.3 Transfer Surface Size Recommendations for Stretchers (M301)
  
 - 
    
  
  EZ-ACCESS® Incline Calculator for Ramp Solutions
  
EZ-ACCESS® Incline Calculator [Click here to access the online calculator] To Establish the Proper Ramp Length: Determine the incline that your chair is designed to...
 - 
    
  
  Door and Gate Surfaces [§404.2.10]
  
Door and Gate Surfaces [§404.2.10] The bottom surface of doors and gates on the push side must be smooth to a height of at least 10”....
 - Access Board: Unobstructed Side Reach
 - 
    
  
  Spas
  
Spas Spas must provide at least one accessible means of entry, which can be a pool lift, transfer wall, or transfer system. ...
 - 
    
  
  M303.3.3.4 Edge Protection
  
Ramps with drop offs ½ inch (13 mm) or greater shall provide edge protection 2 inches (50 mm) high minimum on each side....
 - 
    
  
  Transfer Surface Size: Equipment Used by Patients in Supine, Prone, or Side-Lying Position (M301.2.2)
  
For surfaces on which patients lie down, ANSI/AAMI HE75 recommends that “patients should be able to roll to a side or prone position with minimal need to lift or shift their center of gravity...
 - 
    
  
  9.b [§ 4.7.5]
  
9.b [§ 4.7.5] If the sidewalk at the top of the ramp (“x”) is less than 48 inches wide and the curb ramp you are surveying has flared sides, answer this question....
 - 
    
  
  Ramps M303:3.3, 3.3.1, 3.3.2
  
Ramps M303:3.3, 3.3.1, 3.3.2 M303.3 Proposed Provision: Changes in Level at Entry to Wheelchair Spaces includes technical criteria for changes in level at the entry to a wheelchair space...
 - 
    
  
  9.a [§ 4.7.5]
  
To answer this question you need to determine the slope of the flared sides to make sure it is 10 percent or less....
 - 
    
  
  406.5 Location
  
Curb ramps and the flared sides of curb ramps shall be located so that they do not project into vehicular traffic lanes, parking spaces, or parking access aisles....
 - 
    
  
  406.5 Location
  
Curb ramps and the flared sides of curb ramps shall be located so that they do not project into vehicular traffic lanes, parking spaces, or parking access aisles....
 - 
    
  
  c. Transfer Surface Size for Diagnostic Equipment Used by Patients in the Supine, Prone, or Side-lying Position
  
The MDE Advisory Committee differentiated between equipment whose transfer surface was located on the end of the equipment with transfer sides on one short side and one long side of adjoining...
 - 
    
  
  Portable ramp - step 6 inches or less
  
[See subsections ...]
 - 
    
  
  Exceptions Considered for Wheelchair Spaces on Raised Platforms
  
The exception to the minimum width in M303.2.2 would apply where ramped surfaces are provided on the opposite sides of the raised platform so that patients using wheelchairs can enter and...
 - 
    
  
  1. Standing Supports
  
entry raised platforms....
 - 
    
  
  Self Contained, Closed Products - Side Reach Range
  Requires the Accessibility Specialist plan or above. (Login or upgrade your account!)
 - 
    
  
  M303.3.3 Ramped (Section-by-Section Analysis)
  
The MDE NPRM proposed that for equipment with a change in level at the entry of a wheelchair space, level changes greater than ½ inch high would be required to be ramped and comply with...
 - Patriot Portable Lift by Aqua Creek Products
 - seca 664 - electronic wheelchair scale_without comments - seca1840
 - 
    
  
  11B-1002.4.4.2 Side entry
  
Where wheelchair spaces are entered only from the side, amusement rides shall be designed to permit sufficient maneuvering clearance for individuals using a wheelchair or mobility aid to...
 - 
    
  
  11B-1002.4.4.2 Side entry
  
Where wheelchair spaces are entered only from the side, amusement rides shall be designed to permit sufficient maneuvering clearance for individuals using a wheelchair or mobility aid to...
 - 
    
  
  11B-1002.4.4.2 Side entry
  
Where wheelchair spaces are entered only from the side, amusement rides shall be designed to permit sufficient maneuvering clearance for individuals using a wheelchair or mobility aid to...
 - 
    
  
  4.25.3 HEIGHT
  
Accessible storage spaces shall be within at least one of the reach ranges specified in 4.2.5 and 4.2.6. Clothes rods shall be a maximum of 54 in (1370 mm) from the floor (see Fig....