All areas of newly designed and newly constructed buildings and facilities and altered portions of existing buildings and facilities shall comply with these requirements....
Search Results "Existing Trail"
Filters
Commonly Searched Documents
-
11B-201.1 Scope
-
R101 Purpose (Section-by-Section Analysis)
The proposed guidelines do not address existing facilities unless they are included within the scope of an alteration to an existing facility undertaken at the discretion of a covered entity...
-
Exemptions for Entire Trail or Beach Access Route
percent for over 20 feet; A trail obstacle 30 inches high or more runs across the full tread width of the trail; The trail surface is neither firm nor stable for a distance...
-
Exception for accessible means of egress in existing buildings in IBC 2000
Exception: Accessible means of egress are not required in alterations to existing buildings....
-
11B-249.1.3
On or after January 1, 2025, alterations to existing commercial places of public amusement which require a permit or for which the estimated cost is ten thousand dollars ($10,000) or more...
-
TECHNICALLY INFEASIBLE
[DSA-AC] An alteration of a building or a facility, that has little likelihood of being accomplished because the existing structural conditions require the removal or alteration of a load-bearing...
-
4.1.5 Accessible Buildings: Additions
Each addition to an existing building or facility shall be regarded as an alteration....
-
11B-215.1 General
Exception: In existing facilities, visible alarms for fire alarm systems shall not be required except where an existing fire alarm system is upgraded or replaced, or a new fire alarm system...
-
F202.1 General
Additions and alterations to existing buildings or facilities, including leased buildings or facilities, shall comply with F202....
-
1017.5 Tread Obstacles
Tread obstacles on trails, passing spaces, and resting intervals shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
-
1017.5 Tread Obstacles
Tread obstacles on trails, passing spaces, and resting intervals shall not exceed 1/2 inch (13 mm) in height measured vertically to the highest point....
-
Fishing piers and platforms. (Section-by-Section Analysis)
In existing facilities, moreover, gangways need not be lengthened to meet the requirement (except, in an alteration, as may be required by the path of travel requirement)....
-
§8.25(b) Existing public housing and multi-family Indian housing—general
(b) Existing public housing and multi-family Indian housing—general. The requirements of §8.24(a) shall apply to public housing and multi-family Indian housing programs....
-
Firm
Firm. A firm surface resists deformation by indentations. During the planning process, firmness must be evaluated for noticeable distortion or compression during the seasons...
-
Stable
Stable. A surface is not permanently affected by expected weather conditions and can sustain normal wear and tear from the expected use(s) of the area, between planned...
-
7.4.12.1 Clear Width
Gate openings and openings in barriers for hiker passage shall provide a clear width of 36 inches (915 mm), complying with ODAAG, section 1017.3 Clear Tread Width.
-
F247.4.4 Routes
Routes that connect trails complying with 1017 to camping facilities, picnic facilities, viewing areas, pit toilets, and accessible elements provided within the facilities shall comply with...
-
General [§202.1]
General [§202.1] Additions and alterations undertaken at existing facilities are covered by the ADA Standards....
-
11B-101.2 Reserved
[2010 ADAS] 101.2 Effect on Removal of Barriers in Existing Facilities. This document does not address existing facilities unless altered at the discretion of a covered entity....
-
11B-101.2 Reserved.
[2010 ADA Standards] 101.2 Effect on Removal of Barriers in Existing Facilities....
-
1003.2.13 Accessible means of egress
Exception: Accessible means of egress are not required in alterations to existing buildings....
-
§104.22(c) Small health, welfare, or other social service providers
after consultation with a handicapped person seeking its services, that there is no method of complying with paragraph (a) of this section other than making a significant alteration in its existing...
-
8. How do I determine if it is readily achievable for me to install a lift in my existing pool?
How do I determine if it is readily achievable for me to install a lift in my existing pool?...
-
§ 35.150(b)(2)(i) Safe harbor
Elements that have not been altered in existing facilities on or after March 15, 2012 and that comply with the corresponding technical and scoping specifications for those elements in either...