[See subsections ...]
Search Results "Dining Surface"
Filters
Commonly Searched Documents
-
A4.5 Ground and Floor Surfaces
-
4.5 Ground and Floor Surfaces
[See subsections ...]
-
A4.5 GROUND AND FLOOR SURFACES.
[See subsections ...]
-
4.5 GROUND AND FLOOR SURFACES
[See subsections ...]
-
R404.2 Surfaces
R404.2 Surfaces....
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
404.2.4.4 Floor or Ground Surface
404.2.4.4 Floor or Ground Surface. Floor or ground surface within required maneuvering clearances shall comply with 302. Changes in level are not permitted. EXCEPTIONS: 1....
-
T405.2 Surfaces
Step tread surfaces shall comply with T302....
-
Dimensional Tolerances in Construction and for Surface Accessibility
[See subsections ...]
-
4.34.2(15)
(b) The dining area. (c) The sleeping area, or the bedroom in one bedroom dwelling units, or at least two bedrooms or sleeping spaces in dwelling units with two or more bedrooms....
-
U.S. Forest Service Accessible Picnic Table Designs - Steel Leg Picnic Table
-
U.S. Forest Service Accessible Picnic Table Designs - Wood Picnic Table
-
U.S. Forest Service Accessible Picnic Table Designs - Stone Leg Picnic Table
-
405.4 Floor or Ground Surfaces
Floor or ground surfaces of ramp runs shall comply with 302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
405.4 Floor or Ground Surfaces
Floor or ground surfaces of ramp runs shall comply with 302. Changes in level other than the running slope and cross slope are not permitted on ramp runs....
-
Highway standards suggesting possible applications for pedestrian surfaces
ASTM E 950-98(2004) Standard test method for measuring the longitudinal profile of traveled surfaces with an accelerometer established inertial profiling reference...
-
B. Accessible Route
B. Is there a route to these 5% accessible fixed tables that allows at least 36" clear width and has no abrupt vertical level changes greater than 1/4"? [ADA Stds. 5.3;4.3.8] Yes...
-
12181(7)(B)
(B) a restaurant, bar, or other establishment serving food or drink;
-
R409.6 Gripping Surface
R409.6 Gripping Surface. Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
Loose Fill Surfaces
Loose Fill Surfaces. The predominant surface characteristic is one where many loose particles are combined to create the surface system. ...
-
11B-802.1.1 Floor or ground surface
The floor or ground surface of wheelchair spaces shall comply with Section 11B-302. Changes in level, slopes exceeding 1:48, and detectable warnings shall not be permitted....
-
Performance for Surface Firmness and Stability
Performance for Surface Firmness and Stability In addition to the visual inspection and calculation of the surface deficiency score, the firmness and stability of the surfaces were measured...
-
11B-809.9.4 Work surfaces
Work surfaces shall be 36 inches (914 mm) maximum above the finish floor with minimum lengths at the following locations as required by this section: Linear length of 30 inches...
