Detectable warnings shall extend the full width of the ramp run less 2 inches (51 mm) maximum on each side, excluding any flared sides....
Search Results "Grade 2 Braille"
-
11B-705.1.2.2 Curb ramps
-
11B-411.2.2.1 Visible identification
The character on the fixture shall be upper case with a height of 2 1/2 inches (64 mm) minimum complying with Sections 11B-703.5.1, 11B-703.5.3, 11B-703.5.4, 11B-703.5.7 and 11B-703.5.8....
-
2.5.2.1 International Electrotechnical Commission (IEC) Standards
IEC 60601-1 is also accompanied by a set of “Part 2” or “Particular” standards, designated as the 60601-2-xx series of standards....
-
E201.1 Scope (Section-by-Section Analysis)
Section-by-Section Analysis) This section proposes that ICT procured, developed, maintained, or used by agencies must conform to the proposed requirements set forth (or referenced) in 508 Chapter 2....
-
GUARD OR GUARDRAIL
GUARD [DSA-AC , HCD 1 & HCD 2] OR GUARDRAIL. ...
-
804.6.2 Operable Parts
Appliance doors and door latching devices shall not be required to comply with 309.4. 2....
-
804.6.2 Operable Parts
Appliance doors and door latching devices shall not be required to comply with 309.4. 2....
-
1i
Are all of the small showers free of curbs or lips greater than 1/2" high at the shower floor that would impede wheelchair approach and transfer onto the folding shower seat?...
-
§8.28(a)(5)
(5) If necessary as a reasonable accommodation for a person with disabilities, approve a family request for an exception rent under §982.504(b)(2) for a regular tenancy under the Section...
-
4(4)
Thresholds and changes in level at these locations are beveled with a slope no greater than 1:2....
-
303.1 General
Animal containment areas shall not be required to comply with 303. 2. Areas of sport activity shall not be required to comply with 303....
-
4.21.7 Curbs
If provided, curbs in shower stalls 36 in by 36 in (915 mm by 915 mm) shall be no higher than 1/2 in (13 mm)....
-
4.1.6(1)(i)
hazardous material abatement, or automatic sprinkler retrofitting, and does not involve the alteration of any elements or spaces required to be accessible under these guidelines, then 4.1.6(2)...
-
6.10 Openings
Openings in the surface of beach access routes and their related resting intervals may be up to 1/2 inch (13 millimeters) wide....
-
6.3 Minimum Number
At least one beach access route shall be provided for each 1/2 mile of shoreline where required by 6.2....
-
11B-505.7.2 Non-circular cross sections
Handrail gripping surfaces with a non-circular cross section shall have a perimeter dimension of 4 inches (102 mm) minimum and 6¼ inches (159 mm) maximum, and a cross-section dimension of 2¼...
-
§ 38.31(b)
(b) Other stepwells and doorways, including doorways in which lifts or ramps are installed, shall have, at all times, at least 2 foot-candles of illumination measured on the step tread,...
-
11B-505.7.2 Non-circular cross sections
Handrail gripping surfaces with a non-circular cross section shall have a perimeter dimension of 4 inches (102 mm) minimum and 6¼ inches (159 mm) maximum, and a cross-section dimension of 2¼...
-
11B-809.10.6.2 Slope
The slope of the shower floor shall be 1/2 inch (12.7 mm) per foot maximum in any direction and shall slope to a drain....
-
§8.23(a) Substantial alteration
If alterations are undertaken to a project (including a public housing project as required by §8.25(a)(2)) that has 15 or more units and the cost of the alterations is 75 percent or more...
-
ADA Checklist for Existing Facilities
requirements for nondiscriminatory policies and practices and for the provision of auxiliary aids and services, such as sign language interpreters for people who are deaf and material in Braille...
-
2.2.2 Structural Anthropometry (i.e. Body and WhMD Dimensions)
FaroArm, Faro Technologies Inc.) was used to record the 3-D location of body and WhMD device points (Figure 2‒2)....
-
Yale 1900 Series Traditional Door Closers
Features ANSI/BHMA Grade 3 Certified Spring power adjustment Aluminum alloy shell Regulating valve Rack & pinion operation Available...
-
Allegion LCN 3030 Series Overhead Concealed Door Control
Features and Benefits The 3030 Series is UL and cUL listed with regular arm for self-closing doors Tested and certified under ANSI Standard A156.4, grade one Specifications...
