The IBC requires an evacuation elevator designed with standby power and other safety features that can be used for emergency evacuation of individuals with disabilities in facilities with...
Search Results "Visible Indicator (Elevator Car)"
Commonly Searched Documents
-
General
-
Maximum side reach ranges. (Section-by-Section Analysis)
Reach ranges apply to a variety of building elements, including light switches, key pads, electrical outlets, fire alarm pulls, card readers, thermostats, elevator controls, pay phones,...
-
G. What are Detectable Warnings, Why are They Required, and Where Must They be Provided?
The warnings, which are intended to be felt with pedestrians’ feet, alert blind individuals and those with low vision that they are about to enter a street or other area where cars pass....
-
Attachment B – Code References
Altering existing elevators. Altering existing steps. Altering existing handrails. 4....
-
Wayfinding is more than just graphics (slides 2 – 4)
Audio Cues (slide 3) We use audio cues to know that the elevator has arrived. It makes a dinging noise....
-
Section 36.211 Maintenance of accessible features (Section-by-Section Analysis)
Section 36.211(a) broadly covers all features that are required to be accessible under the ADA, from accessible routes and elevators to roll-in showers and signage. ...
-
Q10: What should a school district do if it does not believe that a student needs special education or related services as described in the Section 504 regulation?
of possible modifications include: allowing a student who has a physical disability based on a lung condition that substantially limits walking and mobility to use the faculty elevator...
-
Section 35.133 Maintenance of Accessible Features (Section-by-Section Analysis)
Section 35.133(a) broadly covers all features that are required to be accessible under the ADA, from accessible routes and elevators to roll-in showers and signage. ...
-
6. PV Systems at Parking Facilities
Whether or not a reasonable portion of accessible parking will be shaded or covered by the PV system elevated components....
-
3. Terminology
3.1 Definitions: 3.1.1 Terminology used in this practice conforms to the definitions included in Terminology E867. 3.1.1.1 longitudinal profile measurement, n—a series of elevation...
-
II-3.10000 Maintenance of accessible features
Mechanical failures in equipment such as elevators or automatic doors will occur from time to time....
-
22. Q. We are building a new prison. Do we need to make it accessible?
Either the Uniform Federal Accessibility Standards (UFAS) or the ADA Standards for Accessible Design (without the elevator exemption) (ADA Standards) may be used....
-
Section 2. Accessible route
Interior accessible routes may include corridors, floors, ramps, elevators and lifts. Exterior accessible routes may include parking access aisles, curb ramps, walks, ramps and lifts....
-
§100.201 Accessible route
Interior accessible routes may include corridors, floors, ramps, elevators, and lifts....
-
A. Arena Assembly Seating:
The floor surface of the Companion Seat shall be at the same elevation as the floor surface of the Wheelchair Seat. ...
-
1.1.7 Measurement of parking areas
This means that the overall slope in the long dimension should be measured along the center of the aisle or zone using the ends of the area as elevation measuring points and cross slope...
-
Required Compliance [§210]
., ramp or elevator) are not required to meet the Standards, but handrails must comply when stairs that are part of a means of egress are altered (§210.1, Ex. 2)....
-
1009.11 Instructions
Information on planned availability of assistance in the use of stairs or supervised operation of elevators and how to summon such assistance....
- Ascension Virtuoso 5460F Vertical Permanently-Installed Wheelchair Lift
-
3.3 Guidance on the Visual Properties of Detectable Warnings
However, low contrast detectable warnings might be sufficient if other methods are be used to increase the visibility of the curb ramp (e.g., if the entire curb ramp contrasts visually with...
-
Meeting ANSI Standard S12.60 Requirements
The NRC indicates the average percentage of sound that a ceiling absorbs and is expressed as a number between 0.00 and 1.00....
-
Background
In this report, the term SEWF refers to ìstabilizedî EWF and indicates the system with the bonded top layer of EWF....
-
DSA IR 11B-6 MECHANICAL ONLY PROJECTS EXEMPT FROM ACCESSIBILITY REVIEW (with revisions issued through Jan. 2011)
This IR indicates an acceptable method for achieving compliance with applicable codes and regulations, although other methods proposed by design professionals may be considered by DSA....
-
Manual vs. Power (RMS Values)
This could indicate that the size of gaps in surfaces may be more important than the frequency of the gaps....