Cross slopes—the side-to-side slope of a trail tread (figure 131)—provide drainage to keep water from ponding and damaging the trail, especially on unpaved surfaces....
Search Results "Side Transfer Surface"
Filters
Commonly Searched Documents
-
Trail Slopes
-
11B-806.2.3 Sleeping areas
At least one sleeping area shall provide a 36 inch (914 mm) by 48 inch (1219 mm) minimum clear space on both sides of a bed....
-
11B-806.2.3 Sleeping areas
At least one sleeping area shall provide a 36 inch (914 mm) by 48 inch (1219 mm) minimum clear space on both sides of a bed....
-
11B-806.2.3 Sleeping areas
At least one sleeping area shall provide a 36 inch (914 mm) by 48 inch (1219 mm) minimum clear space on both sides of a bed....
-
Signage
Requirements: Signs that are provided for all permanent rooms and spaces in the lodging facility must be mounted on the wall (not the door) adjacent to the latch side of the door and...
-
§ 37.47(b)(2)
(2) Transfer stations on a rail line or between rail lines;...
-
§ 37.51(b)(2)
(2) Transfer stations on a rail line or between rail lines;...
-
Rectangular Seats: ADA Standard Section 610.3.1
Section 610.3.1 covers the current ADA Standards for rectangular shower compartment seats.
-
11B-610.3.1 Rectangular seats
The side edge of the seat shall be 1½ inches (38 mm) maximum from the adjacent wall....
-
11B-809.9.2 Clear width
Kitchens shall have a minimum clear width measured between any cabinet, work surface or the face of any appliance (excluding handles and controls) and the opposing cabinet, work surface,...
-
1004 Exercise Machines
This section requires clear floor space for transfer to, or use of, exercise machines....
-
Standard Roll-In Type Shower Compartments: ADA Standard Section 608.2.2
Section 608.2.2 covers the current ADA Standards for the size of standard roll-in type shower compartments.
-
Flush Controls: ADA Standard Section 604.9.5
Section 604.9.5 covers the current ADA Standards for flush controls on children's use water closets.
-
11B-502.3.4 Location
Access aisles shall be permitted to be placed on either side of the parking space except for van parking spaces which shall have access aisles located on the passenger side of the parking...
-
11B-502.3.4 Location
Access aisles shall be permitted to be placed on either side of the parking space except for van parking spaces which shall have access aisles located on the passenger side of the parking...
-
11B-604.8.2.2 Doors
side of the compartment and any obstruction shall be 44 inches (1118 mm) minimum....
-
11B-502.3.4 Location
Access aisles shall be permitted to be placed on either side of the parking space except for van parking spaces which shall have access aisles located on the passenger side of the parking...
-
11B-604.8.2.2 Doors
side of the compartment and any obstruction shall be 44 inches (1118 mm) minimum....
-
Taking Measurements
Taking Measurements Sloped Surfaces One way to measure slope is to use a 24-inch level with leveling bubble and a tape measure....
-
Adjustable height protocol
The amount of vertical distance that the seat was raised/lowered each time depended on the subject’s perceived and observed transfer abilities....
-
11B-407.4.10 Support rail
Support rails in elevator cabs are used in a different way than handrails along a walking surface such as a ramp or stairway....
-
Pilot Rock Bench B110C with Full-length Grab Bar
The full-length grab bar across the back of the bench enhances access and transfer to or from this bench....
-
11B-404.2.4.1 Swinging doors and gates
Perpendicular to doorway Parallel to doorway (beyond latch side unless noted) From front Pull 60 inches...
-
11B-404.2.4.1 Swinging doors and gates
CLEARANCES AT MANUAL SWINGING DOORS AND GATES TYPE OF USE MINIMUM MANEUVERING CLEARANCE Approach direction Door or gate side...
