available in standard colors Optional colors available for an upcharge Coordinating litter receptacles and ash urn Arm Options: A tablet arm may be specified on one or both ends...
Search Results "End Transfer Surface"
Commonly Searched Documents
- Landscape Forms Inc. Washington Square Bench Collection
-
406.2 Counter Slope
Counter slopes of adjoining gutters and road surfaces immediately adjacent to the curb ramp shall not be steeper than 1:20....
-
707.6.3.1 Contrast
Function keys shall contrast visually from background surfaces. Characters and symbols on key surfaces shall contrast visually from key surfaces....
- AJW Architectural Products U122 128 oz. Dual Valve Liquid Soap Dispenser w/ Shelf - Surface Mounted
- AJW Architectural Products U120 128 oz. Single Valve Liquid Soap Dispenser w/ Shelf - Surface Mounted
- AJW Architectural Products U1525EA Series Automatic 120 Volt Hand Dryer, White Powder Coat - Surface Mounted
- AJW Architectural Products U815 Dual Toilet Tissue Dispenser w/ Mounted Shelf - Surface Mounted - Non-Controlled
- AJW Architectural Products U590 1.6 Gallon Sanitary Napkin Disposal w/ Keyed Access Panel - Surface Mounted
- AJW Architectural Products UJ11 Series UJ11A Coat Hook Strip 24"L, 3 Hooks - Surface Mounted
-
PART 3: ACCESSIBLE EXAMINATION ROOMS
.); and adequate clear floor space inside the room for side transfers and use of lift equipment....
- GameTime Nature Discovery Table
-
410.6 Doors and Gates
End doors and gates shall provide a clear width 32 inches (815 mm) minimum. Side doors and gates shall provide a clear width 42 inches (1065 mm) minimum....
-
11B-410.6 Doors and gates
End doors and gates shall provide a clear width 32 inches (813 mm) minimum. Side doors and gates shall provide a clear width 42 inches (1067 mm) minimum....
-
2. REGULATORY BUILT-IN TOLERANCES
Building Code Section 1101B.5 indicates all dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end...
-
610.3.2 L-Shaped Seats
The end of the "L" shall be 22 inches (560 mm) minimum and 23 inches maximum (585 mm) from the main seat wall....
-
11B-604.5.1 Side wall
wall grab bar shall be 42 inches (1067 mm) long minimum, located 12 inches (305 mm) maximum from the rear wall and extending 54 inches (1372 mm) minimum from the rear wall with the front end...
-
11B-707.6.1 Input controls
Where provided, key surfaces not on active areas of display screens, shall be raised above surrounding surfaces....
-
707.6.1 Input Controls
Where provided, key surfaces not on active areas of display screens, shall be raised above surrounding surfaces....
-
707.6.1 Input Controls
Where provided, key surfaces not on active areas of display screens, shall be raised above surrounding surfaces....
-
11B-707.6.1 Input controls
Where provided, key surfaces not on active areas of display screens, shall be raised above surrounding surfaces....
-
Trail Type
There are three Trails Types: Standard/Terra Trail: A trail that has a surface consisting predominantly of the ground and that is designed and managed to accommodate use on that surface...
-
Connections [1018.2]
Whenever possible, providing a beach access route that extends into the water will allow people to remain in their mobility devices and to transfer directly into the water....
-
2. Roll-in Shower Size
more than 50 guestrooms/suites, are all required roll-in showers at least 30" wide by 60" long or 36" wide by 60", as configured in Figure 57 below, so persons who use wheelchairs may transfer...
-
Size and Clearances [4.21.2]
Recommendation: Twelve inches of additional clear floor space at the seat will facilitate side transfers....