be relocated to between 48 inches measured to the baseline of the lowest tactile character and 60 inches measured to the baseline of the highest tactile character above the finish floor surface...
Search Results "Reflecting Surface"
Filters
Commonly Searched Documents
-
D. Signage
-
A. Accessible Entrance
Accessible Entrance Having a way to get into the emergency shelter on a surface that is firm, stable, slip resistant, without steps or steep slopes, and wide enough for a person using...
-
11B-411.2.1.6 Identification of floors served
consoles located on floors with a building entry, including parking and transfer levels, shall be provided with signage complying with Sections 11B-703.2, 11B-703.3, and 11B-703.5 on the surface...
-
4.4.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
Conventional Strollers
The small pivoting front wheels on these strollers make them fairly easy to maneuver, but limit their use on unpaved surfaces or rough pavement....
-
11B-411.2.1.6 Identification of floors served
consoles located on floors with a building entry, including parking and transfer levels, shall be provided with signs complying with Sections 11B-703.2, 11B-703.3, and 11B-703.5 on the surface...
-
11B-602.9 Pedestrian protection
When used, wing walls or barriers shall project horizontally at least as far as the drinking fountain and to within 6 inches (152 mm) vertically from the floor or ground surface....
-
11B-1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (864 mm) maximum above the ground or deck surface....
-
11B-411.2.1.6 Identification of floors served
consoles located on floors with a building entry, including parking and transfer levels, shall be provided with signs complying with Sections 11B-703.2, 11B-703.3, and 11B-703.5 on the surface...
-
11B-1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (864 mm) maximum above the ground or deck surface....
-
Expert Report of John Rife Torkelson, theACCESSpartnership, L.P. (August 8, 2018)
Parking: The surface slope of the designated accessible van space exceeds the maximum slope allowed of 1:48 (1991 ADA Stds 4.6.3; 2010 ADA Stds 502.4)....
-
Reinventing the Wheel
founder, Reveca Torres, after she conducted an online “disability” image search; the search generated mostly somber, sad, and hopeless imagery that perpetuated stereotypes and failed to reflect...
-
Shared Use Paths: ADA Standard Section 2.
address access to sidewalks, streets, and other pedestrian facilities, provide requirements for pedestrian access routes, including specifications for route width, grade, cross slope, surfaces...
-
11B-609.3 Spacing
Section 11B-609.9 the space between the walls and the grab bar shall be 1½ inches (38 mm) minimum for a distance of 6 inches on either side of the inside corner between two adjacent wall surfaces...
-
"Readily achievable.'' (Preamble, Section-by-Section Analysis)
It reflects the congressional intention that a wide range of factors be considered in determining whether an action is readily achievable....
-
2. The ADA Title III Regulation
This list was revised in 2010 to reflect changes in technology and the auxiliary aids and services commonly used by individuals who are deaf or hard of hearing or blind or have low vision...
-
Issue 17: What design guidance on artificial/electric lighting for low vision persons can be provided in the short term?
So what you have to do is get into the project really early and start telling them that we need light reflectance values on all the large spaces....
-
Section 36.102 Application (Preamble, Section-by-Section Analysis)
On the other hand, as mandated by the ADA and reflected in § 36.102(c), the new construction and alterations requirements of subpart D apply to a commercial facility whether or not the facility...
-
Section 610 Review.
The proposals reflect the Department's analysis and review of complaints or comments from the public as well as changes in technology. ...
-
Element-by-element safe harbor for public accommodations. (Section-by-Section Analysis)
The proposed safe harbor reflects the Department's determination that it would be an inefficient use of resources to require covered entities that have complied with the 1991 Standards to...
-
17. Tests and selection criteria
The test results will not, therefore, predict job performance but instead will reflect impaired speech....
-
Section 610 Review.
The proposals reflect the Department's analysis and review of complaints or comments from the public as well as changes in technology. ...
-
407.3 Tactilely Discernible (Section-by-Section Analysis)
This proposed exception would be a significant departure from the 508 Standards and 255 Guidelines, but more accurately reflects the state of current technology....
