Design Tip Determine parking requirements for walk-in camping units....
Search Results "United States Supreme Court"
-
Vehicle Parking
-
Section 36.103 Relationship to Other Laws (Preamble, Section-by-Section Analysis)
Paragraph (c) makes clear that Congress did not intend to displace any of the rights or remedies provided by other Federal laws or other State or local laws (including State common law)...
- DOE "Dear Colleague" Letter: ADA Amendments Act of 2008 and Students with Disabilities Attending Public Elementary and Secondary Schools (Jan. 19, 2012)
- Colorado Developmental Disabilities Council
- Northern Regional Center for Independent Living (NRCIL) - Watertown and Lowville, NY
-
XI. GENERAL & MISCELLANEOUS PROVISIONS
This Agreement shall be governed by the laws of the State of California. 48. This Agreement may be signed in duplicate originals. 49....
-
Monitoring and Fees
Plaintiffs’ monitoring fees, costs and expenses, exclusive of any disputes resolved by the District Court, shall be paid out of the Annual Commitment and be capped as follows: Years 1...
- The National Association of Councils on Developmental Disabilities (NACDD)
- Hussey Seating Company Flip-Up Armrest
- Hussey Seating Company Skid-Mounted and Companion Chairs
-
11B-411.2.1.6 Identification of floors served
entry, including parking and transfer levels, shall be provided with signs complying with Sections 11B-703.2, 11B-703.3, and 11B-703.5 on the surface of or above the hall call console stating...
-
11B-411.2.1.6 Identification of floors served
entry, including parking and transfer levels, shall be provided with signs complying with Sections 11B-703.2, 11B-703.3, and 11B-703.5 on the surface of or above the hall call console stating...
-
704.11.1 Parapet construction
Where the roof slopes toward a parapet at a slope greater than two units vertical in 12 units horizontal (16.7-percent slope), the parapet shall extend to the same height as any portion...
-
8. Report
include the date and time of day of the measurement, the location of the measurement, length of measurement, and the descriptions of the surface being measured. 8.1.3 PRI Resolution—If units...
-
1132A.4.1 Thresholds
Thresholds with a change in height between ¼ inch (6.35 mm) and 3/4 inch (19.05 mm) shall be beveled with a slope no greater than 1 unit vertical in 2 units horizontal (50-percent slope)...
-
A. Executive Order 13563 and 12866—Regulatory Planning and Review
The ADA Amendments Act, which took effect on January 1, 2009, was enacted in response to earlier Supreme Court decisions that significantly narrowed the application of the definition of...
-
E101.3 Conventional Industry Tolerances
Dimensions are subject to conventional industry tolerances except where dimensions are stated as a range....
-
C101.3 Conventional Industry Tolerances
Dimensions are subject to conventional industry tolerances except where dimensions are stated as a range....
-
M101.4 Dimensions
Dimensions that are not stated as "maximum" or "minimum" are absolute....
-
M101.4 Dimensions
Dimensions that are not stated as “maximum” or “minimum” are absolute....
-
§ 37.145(d)
(d) The State shall develop comments to on each plan, responding to the following points:...
-
DIVISION 2: SCOPE AND ADMINISTRATION
Note: Sections adopted or amended by state agencies are specifically indicated by an agency banner....
-
DIVISION II: SCOPE AND ADMINISTRATION
Note: Sections adopted or amended by state agencies are specifically indicated by an agency banner....