Grab bars, shower seats and dressing room bench seat systems shall be designed to resist a single concentrated load of 250 pounds (1.11 kN) applied in any direction at any point on the grab...
Search Results "Interior Design"
-
1607A.8.2 Grab bars, shower seats and dressing room bench seats
-
11B-803.1 General
Partitions and doors should be designed to ensure people using accessible dressing and fitting rooms privacy equivalent to that afforded other users of the facility....
-
1010.1.9.1 Hardware
These design requirements for door handles, pulls, latches, locks and other operating devices, intended for use on required means of egress doors in other than Group R and M occupancies...
-
11B-803.1 General
Partitions and doors should be designed to ensure people using accessible dressing and fitting rooms privacy equivalent to that afforded other users of the facility....
-
Interdisciplinary Communication and Vocabulary
think is so exciting about where he’s going with this is addressing a little bit of the gap analysis that we talked about yesterday, that the physics in terms of parameters that we can design...
-
2.5 Physical Accessibility.
The design and construction of new buildings and the alterations and the necessary structural modifications to existing buildings must comply with accessibility standards under Title II...
-
CS SofStop Pocket Door Kit
The CS SofStop™ pocket door kit is a smooth running, soft closing system designed specifically for pocket doors....
-
Savaria ORION Limited Use/Limited Application Elevator Video
The Orion elevator is designed with features you would expect in a high-rise elevator but built for commercial low-rise buildings. ...
-
Patriot Portable Lift by Aqua Creek Products
The Patriot lift is designed with a weight capacity of 450lbs (204 kg) for most pool configurations for water drafts up to 6″ deep....
-
Attorney areas and witness stands. (Section-by-Section Analysis)
Several commenters mentioned the report ‘‘Justice for All: Designing Accessible Courthouses'' (Nov. 15, 2006), available at http://www.access-board.gov/attachments/article/432/report.pdf...
-
Restaurants and Cafeterias: ADA Standard Section 206.2.5
Section 206.2.5 covers scoping requirements in the most current ADA Standards for accessible routes in restaurants and cafeterias
-
General Holding Cells and General Housing Cells: ADA Standard Section 232.2
Section 232.2 covers scoping requirements in the current ADA Standards for general holding cells and general housing cells.
-
Shared Use Paths: ADA Standard Section 2.
They also differ from trails because they are designed not just for recreation purposes but for transportation as well....
-
11B-216.12 Amusement rides
Amusement rides designed primarily for children, amusement rides that are controlled or operated by the rider, and amusement rides without seats, are not required to provide wheelchair spaces...
-
Intent
for Public Accommodations and Commercial Facilities) and the 2004 Americans with Disabilities Act Accessibility Guidelines, collectively known as the "2010 ADA Standards for Accessible Design...
-
11B-228.3.2 Minimum number
Exceptions: EVCS not available to the general public and intended for use by a designated vehicle or driver shall not be required to comply with Section 11B-228.3.2....
-
11B-216.12 Amusement rides
Amusement rides designed primarily for children, amusement rides that are controlled or operated by the rider, and amusement rides without seats, are not required to provide wheelchair spaces...
-
Intent
for Public Accommodations and Commercial Facilities) and the 2004 Americans with Disabilities Act Accessibility Guidelines, collectively known as the "2010 ADA Standards for Accessible Design...
-
11B-206.2.1 Site arrival points
Department of Transportation and most State departments of transportation are revising their design standards and regulations for the public right of way based on recent research and guidelines...
-
382.87 What other requirements pertain to seating for passengers with a disability?
The one-year delay in the effective date of the rule following publication should be sufficient for foreign carriers to design procedures to carry out these requirements....
-
11B-707.1 General
Token collection devices that are designed to accommodate tokens which are perforated can allow a person to distinguish more readily between tokens and common coins....
-
Drinking Fountains for Standing Persons
The minimum height for the spout outlet of units designed for use by standing persons has been lowered from 39 to 38 inches....
-
Maximum Slope at Ground Level
Designers are encouraged to consider edge protection and handrails on berms where there may be a drop-off. ...
-
§35.172 Resolution of Complaints
§35.172 Resolution of Complaints Section 35.172 requires the designated agency to either resolve the complaint or issue to the complainant and the public entity a Letter of Findings containing...
