more than 50 guestrooms/suites, are all required roll-in showers at least 30" wide by 60" long or 36" wide by 60", as configured in Figure 57 below, so persons who use wheelchairs may transfer...
Search Results "Transfer Surface"
-
2. Roll-in Shower Size
-
Size and Clearances [4.21.2]
Recommendation: Twelve inches of additional clear floor space at the seat will facilitate side transfers....
-
Acknowledgements
Acknowledgements The National Trail Surfaces Study has taken a number of turns over the past several years....
-
505.5 Clearance
Clearance between handrail gripping surfaces and adjacent surfaces shall be 1 1/2 inches (38 mm) minimum....
-
505.5 Clearance
Clearance between handrail gripping surfaces and adjacent surfaces shall be 1 1/2 inches (38 mm) minimum....
-
Detectable Warning
A standardized surface feature built in or applied to walking surfaces or other elements to warn of hazards on a circulation path....
-
Cross Slope [1016.7.2]
Cross slope is the side-to-side slope of the surface of an ORAR....
-
§27.71(k)(6)(iv)(A) Contrast.
Function keys must contrast visually from background surfaces. Characters and symbols on key surfaces must contrast visually from key surfaces....
-
§ 27.71(k)(6)(iv)(A) Contrast
Function keys must contrast visually from background surfaces. Characters and symbols on key surfaces must contrast visually from key surfaces....
-
11B-707.6.1 Input controls
Where provided, key surfaces not on active areas of display screens, shall be raised above surrounding surfaces....
-
11B-707.6.3.1 Contrast
Function keys shall contrast visually from background surfaces. Characters and symbols on key surfaces shall contrast visually from key surfaces....
-
Stabilizer
the surface....
-
ADOPTION OF A 19 INCH HEIGHT MINIMIZES COSTS TO HEALTH CARE PROVIDERS
ADOPTION OF A 19 INCH HEIGHT MINIMIZES COSTS TO HEALTH CARE PROVIDERS In the absence of Committee consensus commending a departure from the existing broadly accepted transfer surface...
-
How is slip resistance measured?
The coefficient of friction between the two surfaces is the ratio of the horizontal and vertical forces required to move one surface over another to the total force pressing the two surfaces...
-
PART 3: ACCESSIBLE EXAMINATION ROOMS
.); and adequate clear floor space inside the room for side transfers and use of lift equipment....
-
11B-407.4.10.1 Location
Clearance between support rails and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
11B-407.4.10.1 Location
Clearance between support rails and adjacent surfaces shall be 1½ inches (38 mm) minimum....
-
Detectable Warning
A standardized surface feature built in or applied to walking surfaces or other elements to warn visually impaired people of hazards on a circulation path....
-
TACTILE WARNING
A standardized surface texture applied to or built into walking surfaces or other elements to warn visually impaired people of hazards in the path of travel....
-
StaLok
During the testing performed in August 2007, it was noted that an individual had walked on the surface at the Wetlands dedication and left marks in the surface of a depth of approximately...
-
3.2 MDE Advisory Committee Process
In all cases except one – the minimum height of transfer surfaces – the Committee reached consensus on the recommended accessibility standards (see Section 5)....
-
1.4 Overview of Report
Section 6 briefly introduces the standard about which Committee members did not reach consensus: the minimum transfer surface height....
-
§382.57(c)(6)(i) Input controls
Where provided, key surfaces not on active areas of display screens, must be raised above surrounding surfaces....
-
Recommendations
Recommendations Based on the data in Table 1 and the observations above, we recommend: a minimum flat surface of 40 in. length for platforms accommodating wheeled mobility devices...