This study found that surface characteristics, more specifically surface roughness, can have a large impact on the WBVs that WC users are exposed to....
Search Results "End Transfer Surface"
Filters
Commonly Searched Documents
-
5. Conclusions
-
Where do I measure for a handrail extension?
ADA section 505.10 calls for a 12 inch handrail extension at the top of stairs beyond the stair nosing or beyond the beginning/end of a ramp run. ...
-
Landscape Forms Inc. Melville Benches
Backless, its end frames flare gently outwards. Bench is 72” in length. Backless or backed. Shorter back rest engineered for comfort....
-
Clearances: ADA Standard Section 403.5
Section 403.5 covers the current ADA Standards for clearances on walking surfaces that are part of an accessible route.
-
Seat Location: ADA Standard Section 1009.2.2
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....
-
11B-1009.2.2 Seat location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....
-
11B-505.10.1 Top and bottom extension at ramps
Extensions shall return to a wall, guard, or the landing surface, or shall be continuous to the handrail of an adjacent ramp run. ...
-
FAQ: How do I enter a New Event in my Corada WorkSpace?
For example, you will use this for events that only say "May 12-15th" but do not provide a start/end time. Does the event provide an end time?...
-
R309.5.1 Location
Locating parking meters at the head or foot of the parking space permits deployment of a van side-lift or ramp or the vehicle occupant to transfer to a wheelchair or scooter....
-
Sample Size Estimation
Data from the maximum and minimum height transfers from protocol A were used for this analysis....
-
Background
A surface that might be firm and stable in one region of the country may be not firm and not stable in another; a surface that may be firm and stable in July may be not firm and not stable...
-
Section 5 References
Section 5 References i http://udeworld.com/analysis-of-seat-height-for-wheeled-mobility-devices ii ”The Impact of Transfer Setup on the Performance of Independent Transfers: Final...
-
Conclusion
Center Study at the University of Buffalo, New York: The Wheeled Mobility Anthropometry Project, Final Report, page 49, Figure 3-5, reference to “All Device Types*”. 3 “The Impact of Transfer...
-
11B.707.7.1.1 Vertically mounted display screen
or tipped away from the viewer less than 30 degrees, the center line of the display screen and other display devices shall be no more than 52 inches (1321 mm) above the floor or ground surface...
-
11B-606.3 Height
Lavatories and sinks shall be installed with the front of the higher of the rim or counter surface 34 inches (864 mm) maximum above the finish floor or ground....
-
Future Work
The devices that are on the market to measure roadway roughness are not applicable to sidewalk and pedestrian surfaces because they either use accelerometers to measure the surface profile...
-
§1607.18 Citations.
When the guidelines are cited in connection with the activities of one of the issuing agencies, a specific citation to the regulations of that agency can be added at the end of the above...
-
222 and 803 Dressing, Fitting, and Locker Rooms
stated that clothing and retail stores would have to expand and reconfigure accessible dressing, fitting and locker rooms to meet the changed provision for clear floor space alongside the end...
-
§100.203(c)
It would be reasonable for the landlord to require the tenant to remove the grab bars at the end of the tenancy....
-
Limitations
Limitations The study is limited in scope by the following: Ability to generalize findings to trails in other locations with the same surfaces applied....
-
F105.2.3 ASTM
ASTM F 1292-99 and ASTM F 1292-04 establish a uniform means to measure and compare characteristics of surfacing materials to determine whether materials provide a safe surface under and...
-
105.2.3 ASTM
ASTM F 1292-99 and ASTM F 1292-04 establish a uniform means to measure and compare characteristics of surfacing materials to determine whether materials provide a safe surface under and...
-
105.2.3 ASTM
ASTM F 1292-99 and ASTM F 1292-04 establish a uniform means to measure and compare characteristics of surfacing materials to determine whether materials provide a safe surface under and...
-
Zurn Insulation Combination Kit: One Trap Protector and Two Stop Supply Protectors
Combination Kit: One Trap Protector and Two Stop Supply Protectors FEATURES: Satin white PVC resin 3/8" Nominal wall with vandal resistant clips ADA compliant and resists thermal transfer...
