Floor identification signs required by Chapter 10, Section 1023.9 complying with Sections 11B-703.1, 11B-703.2, 11B-703.3 and 11B-703.5 shall be located at the landing of each floor level, placed...
Search Results "Commercial Place of Public Amusement"
Filters
Commonly Searched Documents
-
11B-504.8 Floor identification
-
Bobrick Surface-Mounted Toilet Tissue Dispenser with Hoods B-6999
Unit 12 3⁄8" W, 6 3⁄16" H (315 x 155mm); hoods project 4 3⁄4" (120mm) from wall with full roll in place....
-
Bobrick Surface-Mounted Toilet Tissue Dispenser with Hood B-66997
Unit 6 3⁄16" W, 6 3⁄16" H (155 x 155mm); hood projects 4 3⁄4" (120mm) from wall with full roll in place....
-
Bobrick Countertop-Mounted Circular Waste Chute B-529
Provides waste deposit access to receptacle (not furnished) placed under countertop....
-
§382.3 Commuter carrier
passengers on at least 5 round trips per week on at least one route between two or more points according to its published flight schedules that specify the times, days of the week and places...
-
302.3 Openings
Elongated openings shall be placed so that the long dimension is perpendicular to the dominant direction of travel. Figure 302.3 Elongated Openings in Floor or Ground Surfaces ...
-
Mats
Recommendation: ADAAG does not contain provisions for carpet that is not permanently fixed, such as matting placed in lobbies during inclement weather....
-
4.34.2(9)
If air distribution registers must be placed in or close to ceilings for proper air circulation, this specification shall not apply to the registers....
-
4.27.3* HEIGHT
The highest operable part of all controls, dispensers, receptacles, and other operable equipment shall be placed within at least one of the reach ranges specified in 4.2.5 and 4.2.6....
-
1011.2.4 Openings
Elongated openings should be placed so that the long dimension is perpendicular, or as close to perpendicular as possible, to the dominant direction of travel....
-
§ 38.23(c)(1) Design load
Ramps 30 inches or longer shall support a load of 600 pounds, placed at the centroid of the ramp distributed over an area of 26 inches by 26 inches, with a safety factor of at least 3 based...
-
§ 37.203(d)
(d) If there is no other vehicle available to take the place of an OTRB with an inoperable lift, such that taking the vehicle out of service before its next trip will reduce the transportation...
-
Detectable Warnings: ADA Standard Section 810.5.2
Platform boarding edges not protected by platform screens or guards shall have detectable warnings complying with 705 along the full length of the public use area of the platform....
-
Platform Edges: ADA Standard Section 705.2
Detectable warning surfaces at platform boarding edges shall be 24 inches (610 mm) wide and shall extend the full length of the public use areas of the platform....
-
11B-705.1.2.1 Platform edges
Detectable warning surfaces at platform boarding edges shall be 24 inches (610 mm) wide and shall extend the full length of the public use areas of the platform....
-
isUD - Innovative Solutions for Universal Design
Increased employee and visitor satisfaction that leads to increased productivity, repeat visits, and other benefits Proponents of universal design could use the program as a focus of public...
-
11B-216.6 Entrances
Directional signs are needed where the accessible route diverges from the route for the general public and should be located at decision points (for example where the path to the stairs...
-
Moen M–BITION Chrome Two-Handle Pantry Faucet 8957
Moen Commercial's line of M–Bition™medium–duty all metal faucets offer the combination of reliability and style....
-
Moen M–BITION Chrome Two-Handle Pantry Faucet 8940
Moen Commercial's line of M–Bition™medium–duty all metal faucets offer the combination of reliability and style....
-
Moen M–BITION Chrome Two-Handle Pantry Faucet 8948
Moen Commercial's line of M–Bition™medium–duty all metal faucets offer the combination of reliability and style....
-
Moen M–BITION Chrome Two-Handle Kitchen Faucet 8798
Moen Commercial's line of M–Bition™medium–duty all metal faucets offer the combination of reliability and style....
-
Moen M–BITION Chrome Two-Handle Pantry Faucet 8938
Moen Commercial's line of M–Bition™medium–duty all metal faucets offer the combination of reliability and style....
-
Moen M–BITION Chrome Two-Handle Kitchen Faucet 8799
Moen Commercial's line of M–Bition™medium–duty all metal faucets offer the combination of reliability and style....
-
Evaluation of transfers
A majority of our subjects (92% of the sample, CI[86%,96%]) managed a height at 22” (51cm) with no gap in place which is more similar to their own seat height....
