It should be noted that exterior signs are likely to be viewed at a greater distance than interior signs, which would affect the prescribed height of visual characters....
Search Results "Visual Output"
Filters
Commonly Searched Documents
-
11B-216.3 Directional and informational signs
-
4.1.3(14)
(14) If emergency warning systems are provided, then they shall include both audible alarms and visual alarms complying with 4.28....
-
Paragraph (i) Hearing aid coupling (Section-by-Section Analysis)
Paragraph (i) Hearing aid coupling (Section-by-Section Analysis) No substantive comments were received on this provision and no changes were made, other than the editorial...
-
V. Public Information Systems
Two possible types of devices are visual display systems and listening systems....
-
Audio Description Associates Audio Description Services
Audio Description (AD) provides a verbal version of the visual image....
-
Transient Lodging: ADA Standard Section 215.4
Section 215.4 covers scoping requirements in the current ADA Standards for fire alarm systems in transient lodging.
-
Notification Devices: ADA Standard Section 806.3.2
Visible notification devices shall be provided to alert room occupants of incoming telephone calls and a door knock or bell. Notification devices shall not be connected to visible...
-
11B-806.3.2 Notification devices
Visible notification devices shall be provided to alert room occupants of incoming telephone calls and a door knock or bell. Notification devices shall not be connected to visible...
-
2.3.2 IR Receivers
Some under-chin receivers include an output jack into which a neckloop can be plugged for inductive coupling to a hearing aid....
-
Car Position Indicators [4.10.13]
Visual and audible signals that indicate car position are required. Verbal announcements are acceptable and can substitute for chimes or other audible signals....
-
11B-703.8.2 Case
11B-703.8.2 Case. Low resolution VMS characters shall be uppercase.
-
809.5.3 Interconnection
The same visible alarm appliances shall be permitted to provide notification of residential dwelling unit smoke detection and building fire alarm activation.
-
809.5.4 Prohibited Use
Visible alarm appliances used to indicate residential dwelling unit smoke detection or building fire alarm activation shall not be used for any other purpose within the residential...
-
11B-702.1 General
Fire alarm systems shall have permanently installed audible and visible alarms complying with NFPA 72 and Chapter 9, Sections 907.5.2.1 and 907.5.2.3. [2010 ADAS] 702.1 General....
-
809.5.3 Interconnection
The same visible alarm appliances shall be permitted to provide notification of residential dwelling unit smoke detection and building fire alarm activation.
-
809.5.4 Prohibited Use
Visible alarm appliances used to indicate residential dwelling unit smoke detection or building fire alarm activation shall not be used for any other purpose within the residential...
-
809.5.3 Interconnection
809.5.3 Interconnection. The same visible alarm appliances shall be permitted to provide notification of residential dwelling unit smoke detection and building fire alarm activation.
-
809.5.4 Prohibited Use
809.5.4 Prohibited Use. Visible alarm appliances used to indicate residential dwelling unit smoke detection or building fire alarm activation shall not be used for any other purpose...
-
4.28.3(3)
(3) The maximum pulse duration shall be two-tenths of one second (0.2 sec) with a maximum duty cycle of 40 percent. The pulse duration is defined as the time interval between initial...
-
A4.28 Alarms
[See subsections ...]
-
4.28.3(5)
(5) The flash rate shall be a minimum of 1 Hz and a maximum of 3 Hz.
-
Mounting Height
Mounting Height ADAAG specifies a signal height 80 inches above the highest floor level within the space or 6 inches below the ceiling, whichever is lower. (This can be measured...
-
4.28 Alarms
[See subsections ...]
-
4.28 ALARMS
[See subsections ...]
