Bases, enclosures, and fixed seats shall not impede approaches to telephones by people who use wheelchairs....
Search Results "Seat Width"
Filters
Commonly Searched Documents
-
4.31.2 CLEAR FLOOR OR GROUND SPACE
-
§ 37.103(c) Demand responsive systems
If the entity operates a demand responsive system, and purchases or leases a new vehicle other than an automobile, a van with a seating capacity of less than eight persons (including the...
-
§ 37.101(d) Demand Responsive System, Vehicle Capacity Over 16
If the entity operates a demand responsive system, and purchases or leases a vehicle with a seating capacity of over 16 passengers (including the driver) for use on the system, it shall...
-
§ 37.101(c) Fixed Route System. Vehicle Capacity of 16 or Fewer
If the entity operates a fixed route system and purchases or leases a vehicle with a seating capacity of 16 or fewer passengers (including the driver) for use on the system, it shall ensure...
-
§ 38.111(a)(4)
) and (3) to provide table service to a person who wishes to remain in his or her wheelchair and space to fold and store a wheelchair for a person who wishes to transfer to an existing seat...
-
§ 37.205 Additional passengers who use wheelchairs
The operator shall offer boarding assistance and the opportunity to sit in a vehicle seat to passengers who are not assigned a securement location....
-
A) Accessible Parking
If the accessible route is located in front of the space, install wheelstops or other barriers to keep vehicles from reducing width below 36 inches....
-
Serving Counters
A minimum width of 36 inches should be provided with a 42 inch width preferred, if readily achievable....
-
5.2.1.4 Transfer Surface Size Recommendations for Imaging Equipment (M301)
All X-ray tables meet the 28-inch table width....
-
382.67 What is the requirement for priority space in the cabin to store a passenger’s wheelchair?
This requirement applies to aircraft with 100 or more passenger seats....
-
b. Transfer Surface Location
and transfer sides of the transfer surface for diagnostic equipment used by patients in the supine, prone, or side-lying position (M301) and diagnostic equipment used by patients in the seated...
-
G) Parks and Recreation Programs
However, when only some of the ball fields are accessible, the scheduling policies for their use will need to accommodate requests for accessible fields, player areas, or spectator seating...
-
1002.4.4.2 Side Entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
11B-1002.4.4.2 Side entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
Submerged Depth
Landings must be a minimum of 36 inches in width and 60 inches in length. The sloped entry may be a maximum of 30 feet at 1:12 (8.33%) slope before an intermediate landing is required....
-
1002.4.4.2 Side Entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
1002.4.4.2 Side Entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
Edge Protection
Recommendation: At narrow routes in particular, consider maintenance of adjacent surfaces as raised or flush or wider route widths in consideration of minimum maneuvering and passage requirements...
-
Rough Form and Foundation Inspection
slope). 11B-403 Verify forms for sidewalks, ramps, landings, curb ramps and clear floor spaces are correctly installed so proper slopes, cross slopes, widths...
-
Floor Plan of Elevator Cars [4.10.9]
In alterations, smaller car sizes (minimum 47 inch width and 69 inch length) are permitted in cases of technical infeasibility, including where limited by existing shaft configurations (...
-
Shape and Diameter
A gripping surface width between 1¼ to 1½ inches diameter is specified....
-
Rough Form and Foundation Inspection
slope). 11B-403 Verify forms for sidewalks, ramps, landings, curb ramps and clear floor spaces are correctly installed so proper slopes, cross slopes, widths...