Where handrail extensions are provided on gangways or transition plates, the handrail extensions shall not be required to be parallel with the ground or floor surface. 7. ...
Search Results "Surface Smoothness"
Commonly Searched Documents
-
11B-1003.2.1 Boat slips
-
903 Benches
In addition, clarification has been added that the dimensions for back support are measured from the surface of the seat. Comment....
-
APPENDIX A
The presentation revisited some of the recommendations made at the January meeting by the practitioners and clinicians about acceptable transfer surface heights....
-
III. Proposed alternative mechanisms to enhance patient access to diagnostic imaging equipment
For example, in a CT/PET system, the patient support surface is located on top of a transporter, which adds to the height of the transport surface....
-
1.0 APPLICATION
Where existing individual site furnishings are altered or replaced, the floor or ground surface under or around them is not required to be altered solely because an accessible furnishing...
-
Selection of Locations
The selection of the location of the trail surface plots was purposeful within its location in the Wetlands area at Bradford Woods....
-
11B-1003.2.1 Boat slips
The vertical distance is 10 feet (3050 mm) between the elevation where the gangway departs the landside connection and the elevation of the pier surface at the lowest water level....
-
Executive Summary
Detectable warnings are walking surfaces that are primarily intended to provide a tactile cue to pedestrians who are visually impaired....
- ADA Solutions, Inc. Directional Bar Tile
-
10 [§ 4.7.5]
A curb ramp may have returned curbs if it has non-walking surfaces (such as grass) or obstructions on both sides because these conditions would normally discourage pedestrians from walking...
-
11B-1005.2.1 Height
At least 25 percent of the railings, guards, or handrails shall be 34 inches (864 mm) maximum above the ground or deck surface....
-
1003.2.12.1 Height
Guards shall form a protective barrier not less than 42 inches (1067 mm) high, measured vertically above the leading edge of the tread, adjacent walking surface or adjacent seatboard....
-
Handrails
The top of the handrail gripping surface must be a minimum of 34 inches and a maximum of 38 inches above the stair nosing....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space,head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
Openings, Width and Length of Wheelchair Space
Wheelchair spaces must have a clear width of 30 inches minimum and a clear length of 48 inches minimum, measured to at least 9 inches above the floor surface....
-
Will CALGreen be amended to require that some parking spaces are designed so that they can comply with Chapter 11B requirements when converted to EV charging spaces (i.e. slope, vertical clearance, path of travel)?
provide an electrical raceway to the service panel, and provide adequate capacity at the service panel for future EVCS; good design practice would be to incorporate appropriate ground surfaces...
-
R209.1 General
., audible tones and vibrotactile surfaces) to pedestrians who are blind or have low vision....
-
Wheelchair seating locations must provide lines of sight comparable to those provided to other spectators.
A comparable line of sight, as illustrated in the figure below, allows a person using a wheelchair to see the playing surface between the heads and over the shoulders of the persons standing...
-
1003.2.12.1 Height
Guards shall form a protective barrier not less than 42 inches (1067 mm) high, measured vertically above the leading edge of the tread, adjacent walking surface or adjacent seatboard....
-
D. Signage
be relocated to between 48 inches measured to the baseline of the lowest tactile character and 60 inches measured to the baseline of the highest tactile character above the finish floor surface...
-
A. Accessible Entrance
Accessible Entrance Having a way to get into the emergency shelter on a surface that is firm, stable, slip resistant, without steps or steep slopes, and wide enough for a person using...
-
11B-411.2.1.6 Identification of floors served
consoles located on floors with a building entry, including parking and transfer levels, shall be provided with signage complying with Sections 11B-703.2, 11B-703.3, and 11B-703.5 on the surface...
-
4.4.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...