passengers at each gate, ticketing area, and customer service desk that you own, lease, or control at any U.S. or foreign airport, to the extent that this does not interfere with employees' safety...
Search Results "NFSI: National Floor Safety Institute"
-
§382.53(a)(1)
-
§382.119(b)
(b) The covered information includes but is not limited to the following: information concerning flight safety, procedures for takeoff and landing, flight delays, schedule or aircraft changes...
-
Door Protective and Reopening Device [4.10.6]
Door safety edges, used alone as the reopening device, are permitted only in alterations where installation of an automatic reopening device is not technically feasible....
-
§ 38.159(c)(1) Design load
inches (760 mm) or longer shall support a load of 600 pounds (2665 N), placed at the centroid of the ramp distributed over an area of 26 inches by 26 inches (660 mm by 660 mm), with a safety...
-
§ 38.159(d)(7) Seat belt and shoulder harness
For each wheelchair or mobility aid securement device provided, a passenger seat belt and shoulder harness, complying with all applicable provisions of the Federal Motor Vehicle Safety Standards...
-
11B-217.5 Shelves for portable TTYs
Exceptions: Secured areas of detention and correctional facilities where shelves and outlets are prohibited for purposes of security or safety shall not be required to comply with...
- Let’s change the way we think about disability | Joel Dembe | TEDxMississauga
- Rebuilding Together Greater Dallas - Carrollton TX
-
11B-502.6 Identification
Signs shall be 60 inches (1524 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. [2010 ADA Standards] 502.6 Identification....
-
11B-502.6 Identification
Signs shall be 60 inches (1524 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. [2010 ADA Standards] 502.6 Identification....
-
INTRODUCTION
uniform standards adopted by them would, as much as possible, not only comply with the Guidelines adopted by the ATBCB but also be consistent with the standards published by the American National...
- Association of Programs for Rural Independent Living (APRIL)
-
9.1 Overview of Legal Obligations
However, an employer may refuse to hire, or may discharge an individual who is not currently able to perform a job without posing a significant risk of substantial harm to the health or safety...
-
QUESTION: WHAT CONSIDERATIONS APPLY TO PVOs’ OBLIGATION TO PROVIDE ASSISTANCE TO PASSENGERS WITH DISABILITIES WITH RESPECT TO BOARDING AND DISEMBARKING FROM VESSELS?
Part 39 does not require transfers to or from a vessel where a transfer would be contrary to legitimate safety requirements....
-
1.2.2 Alternative materials, design and methods of construction and equipment
material, method or work offered is, for the purpose intended, at least the equivalent of that prescribed in this code in quality, strength, effectiveness, fire resistance, durability and safety...
-
11B.707.7.1.1 Vertically mounted display screen
mounted vertically or tipped away from the viewer less than 30 degrees, the center line of the display screen and other display devices shall be no more than 52 inches (1321 mm) above the floor...
-
11B.707.7.1.1 Vertically mounted display screen
mounted vertically or tipped away from the viewer less than 30 degrees, the center line of the display screen and other display devices shall be no more than 52 inches (1321 mm) above the floor...
-
Coin Slot Height
Is it mounted with the coin slot no higher than 54" above the floor, and one pay phone on that floor with the highest operable element no higher than 48" above the floor?...
- Falcon Waterfree Technologies Vitreous China Urinal F-1000
-
§382.53(b)
(b) The information you must provide under paragraph (a) of this section includes, but is not limited to, the following: Information concerning flight safety, ticketing, flight check-in,...
-
11B-217.5 Shelves for portable TTYs
Secured areas of detention and correctional facilities where shelves and outlets are prohibited for purposes of security or safety shall not be required to comply with Section 11B-217.5....
-
T402.2 Design Load
The factor of safety for ramps and bridgeplates shall be 3 or more, based on the ultimate strength of the material....
-
A4.26.1 General
The grab bar clearance of 1‒1/2 in (38 mm) required in this guideline is a safety clearance to prevent injuries resulting from arms slipping through the openings....