Specifications: Maximum gate length 30-feet. Maximum gate weight 1000 pounds*. (*Assumes gate is on level ground, in good condition with properly adjusted hardware. ...
Search Results "Maximum Extent Practicable"
Filters
Commonly Searched Documents
-
Door King Inc. 9100 Slide Gate Operator Residential & Commercial
-
Wagner Instruments Mark-10 M4 Digital Force Gauge
Analysis Accuracy: ± 0.2% of Full Scale Features Large graphic liquid crystal display of: Primary force reading - 6 digit Peak force readings - maximum...
-
References
Changes in level of ¼ inch (6.4 mm) high maximum shall be permitted to be vertical. 303.3 Beveled....
-
Door King Inc. 6004 Column Mount Swing Gate Operator
Exit and Reverse plug-in loop detectors 90° in approximately 12 seconds Gate overlap feature for dual gate operation Magnetic lock power circuit Built-in reset and test buttons Maximum...
-
4. Drug addicts and alcoholics
on the problems of drug addiction and alcoholism in enacting section 504, the committees that considered the Rehabilitation Act of 1973 were made aware of the Department's long-standing practice...
-
PATH OF TRAVEL
It is also important to note that ADA Title III imposes a perpetual obligation for public accommodations to mitigate existing barriers to the extent readily achievable, not merely limited...
-
DISABILITY
The definition of “disability” shall be construed broadly in favor of expansive coverage, to the maximum extent permitted by the terms of the ADA. ii....
-
11B-307.4 Vertical clearance
The leading edge of such guardrail or barrier shall be located 27 inches (686 mm) maximum above the finish floor or ground....
-
1007.3.2 Golf Club Reach Range Area
All areas within holes where golf balls rest shall be within 36 inches (915 mm) maximum of a clear floor or ground space 36 inches (915 mm) wide minimum and 48 inches (1220 mm) long minimum...
-
1009.4.5 Grab Bars
The top of the gripping surface shall be 4 inches (100 mm) minimum and 6 inches (150 mm) maximum above transfer walls....
-
1004.2.1 Exit or exit access doorways required
TABLE 1004.2.1 SPACES WITH ONE MEANS OF EGRESS OCCUPANCY MAXIMUM OCCUPANT LOAD A,B,E,F,M,U 50 H-1,H-2,H-3 3 H-4,H-5,...
-
11B-502.6.4.2
The centerline of the International Symbol of Accessibility shall be a maximum of 6 inches (152 mm) from the centerline of the parking space, its sides parallel to the length of the parking...
-
608.5.2 Standard Roll-In Type Shower Compartments
Where a seat is provided, the controls, faucets, and shower spray unit shall be installed on the back wall adjacent to the seat wall and shall be located 27 inches (685 mm) maximum from...
-
9.2.2(7) Kitchens, Kitchenettes, or Wet Bars
Counter tops and sinks shall be mounted at a maximum height of 34 in (865 mm) above the floor....
-
4.10.14* EMERGENCY COMMUNICATIONS
The highest operable part of a two-way communication system shall be a maximum of 48 in (1220 mm) from the floor of the car....
-
Unified Facilities Guide Specifications
of surface irregularity is to be determined by placing the straightedge on the pavement surface and allowing it to rest on the two highest spots covered by its length and measuring the maximum...
-
[F] 907.4.2.2 Height
The maximum effort to activate controls shall be no greater than 5 pounds-force.◼...
-
11B-307.4 Vertical clearance
The leading edge of such guardrail or barrier shall be located 27 inches (686 mm) maximum above the finish floor or ground....
-
11B-705.1.2.3 Islands or cut-through medians
warnings at pedestrian islands or cut-through medians shall be 36 inches (914 mm) minimum in depth extending the full width of the pedestrian path or cut-through less 2 inches (51 mm) maximum...
-
11B-809.10.5.1 Clear floor space
The area under a lavatory, located at the control end of the tub, shall be permitted to encroach on the clear floor space provided the lavatory is 19 inches (483 mm) maximum in depth, and...
-
11B-303.3 Beveled
Changes in level between ¼ inch (6.4 mm) high minimum and ½ inch (12.7 mm) high maximum shall be beveled with a slope not steeper than 1:2. Advisory 11B-303.3 Beveled....
-
11B-812.7.2 Marking
The area within the borderlines shall be marked with hatched lines a maximum of 36 inches (914 mm) on center....
-
[F] 907.4.2.2 Height
The maximum effort to activate controls shall be no greater than 5 pounds-force. ◼...
-
5.8.2 Knee and Toe Clearance Recommendations under Breast Platform Recommendations
The depth of the wheelchair space shall include knee and toe clearance of 17 inches minimum and 25 inches maximum....
