[ADA Standards § 4.10.9, Fig. 22] Yes No Note: See Figure 22 for acceptable floor and opening dimensions....
Search Results "Door Opening Angle"
Filters
Commonly Searched Documents
-
e-ii
-
C.8 - Are Section 508 access requirements satisfied if the agency provides such access following a request for it, as opposed to in anticipation of a request for access?
For example, the production of a training video, which is covered by the Section 508 standards, must include the incorporation of open or closed captioning and audio description during the...
-
11B-604.9.5 Flush controls
Flush controls shall be located on the open side of the water closet except in ambulatory accessible compartments complying with Section 11B-604.8.2....
-
5b.
[ADA Stds 4.10.9] Note: See Figure 22 for acceptable floor and opening dimensions....
-
608.5.1 Transfer Type Shower Compartments
mm) minimum and 48 inches (1220 mm) maximum above the shower floor and shall be located on the control wall 15 inches (380 mm) maximum from the centerline of the seat toward the shower opening...
-
Scoping [4.1.3(5)]
elevators only in providing access to: performing areas in assembly occupancies wheelchair seating locations in assembly occupancies incidental space or rooms not open...
-
11B-604.7.2 Disposal units
The disposal unit shall be located below the grab bar, with the opening of the disposal unit 19” minimum (483 mm) above the finish floor....
-
11B-604.9.5 Flush controls
Flush controls shall be located on the open side of the water closet except in ambulatory accessible compartments complying with Section 11B-604.8.2....
-
11B-608.5.1 Transfer type shower compartments
mm) minimum and 48 inches (1219 mm) maximum above the shower floor and shall be located on the control wall 15 inches (380 mm) maximum from the centerline of the seat toward the shower opening...
-
§382.125(c)
(c) You must provide for the checking and timely return of passengers' wheelchairs, other mobility aids, and other assistive devices as close as possible to the door of the aircraft, so...
-
D5
If there is a raised threshold, is it no higher than 3/4 inch at the door and beveled on both sides?...
-
M5
If there is a raised threshold, is it no higher than 3/4 inch at the door and beveled on both sides?...
-
A4.13.8 Thresholds at Doorways
particularly inconvenient for wheelchair users who also have low stamina or restrictions in arm movement because complex maneuvering is required to get over the level change while operating the door...
-
Hardware [4.25.4]
Hardware [4.25.4] Hardware should be exposed (as required for sliding doors in 4.13) and must: be automatic or operable with one hand operate without tight grasping,...
-
A4.13.8 THRESHOLDS AT DOORWAYS
particularly inconvenient for wheelchair users who also have low stamina or restrictions in arm movement, because complex maneuvering is required to get over the level change while operating the door...
-
III-7.5190 Dressing and fitting rooms
Technical standards are provided for doors, benches, and mirrors, with less stringent standards for alterations....
-
Designations: ADA Standard Section 216.2
Section 216.2 covers scoping requirements in the current ADA Standards for sign designations.
-
Application Based on Building or Facility Use: ADA Standard Section 201.2
Section 201.2 covers the application of the most current requirements based on the building or facility use.
-
11B-216.4.2 Areas of refuge and exterior areas for assisted rescue
Signs required by Chapter 10, Section 1009.9 at doors to areas of refuge and exterior areas for assisted rescue shall comply with Sections 11B-703.1, 11B-703.2, 11B-703.3, and 11B-703.5...
-
AJW Architectural Products U640 Series C-fold/Multifold Towel Dispenser & Waste Receptacle Combination - Recessed
Cabinet Door: Fabricated of #22 ga stainless steel with #4 satin finish with full length door stop to prevent vandalism Towel Dispenser: Dispensing area has hemmed edges to prevent injury...
-
AJW Architectural Products U581 Series U581 1.5 Gallon Sanitary Napkin Disposal - Recessed
Product Features Fabricated of #22 gauge stainless steel with a #4 satin finish Waste receptacle has a 1.5 gallon capacity Uni-door construction available see model U5814 Product...
-
AJW Architectural Products U852 Dual Stall Seat Cover Dispenser - Partition Mounted
Door: Fabricated of #22 gauge stainless steel with a #4 satin finish. Seat cover dispensing area is deburred and polished to avoid tearing of product....
-
AJW Architectural Products U852H Dual Stall Seat Cover Dispenser w/ Flush Mounting - Partition Mounted
Door: Fabricated of #22 gauge stainless steel with a #4 satin finish. Seat cover dispensing area is deburred and polished to avoid tearing of product....
-
11B-608.6 Shower spray unit and water
Each shower head shall be installed so it can be operated independently of the other and shall have swivel angle adjustments, both vertically and horizontally....
