resurfacing of circulation paths or vehicular ways, changes or rearrangement of the structural parts or elements, and changes or rearrangement in the plan configuration of walls and full-height...
Search Results "Adjustable Height Exam Table"
-
[A] ALTERATION
-
Reach Range
Accessible reach ranges specify a minimum height of 15 inches (308.3) for unobstructed reaches....
-
606 Lavatories and Sinks
These specifications concern clear floor space requirements (606.2, Exception 3) and heights (606.3, Exception 2)....
-
608.3 Grab Bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor. EXCEPTIONS: 1....
-
608.3 Grab Bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor. EXCEPTIONS: 1....
-
Passenger Loading Zones [4.6.6]
Where aisles are flush with the pull-up space, wheelchair transfer is easier (the change in level of aisles at curb height can make transfer very difficult)....
-
Vertical Clearance [§307.4]
Barriers at Circulation Areas with Reduced Vertical Clearance Recommendation: A minimum height is not specified for barriers demarcating areas with less than 80” of vertical...
-
1.1.12 Ramp cross slope
A simple method of establishing the relative elevations of the top and bottom of each ramp is to use a rotating laser level on a tripod and document the difference in height on a stiff metal...
-
[A] ALTERATION
resurfacing of circulation paths or vehicular ways, changes or rearrangement of the structural parts or elements, and changes or rearrangement in the plan configuration of walls and full-height...
-
11B-604.8.1.5 Grab bars
Where separate grab bars are required on adjacent walls at a common mounting height, an L-shaped grab bar meeting the dimensional requirements of Sections 11B-604.5.1 and 11B-604.5.2 shall...
-
11B-233.3.1.2.6.5 Additional requirements.
Water closet seat height complying with Section 11B-809.10.7.4. 7. Electrical receptacles, switches and controls complying with Section 11B-809.12. 8....
-
Entrances
Additionally, the door hardware must not require tight grasping, pinching, or twisting, and the height of the door threshold must not be greater than ½ inch....
-
212 and 606 Kitchens, Kitchenettes, Lavatories, and Sinks
The technical requirements address clear floor space, height, faucets, and exposed pipes and surfaces....
-
Grab bars
This standard gives the grab bar height range of 4 to 6 inches from the wall to the top of the gripping surface....
-
Accessible Slopes
That means for every inch of height change there should be at least 12 inches of ramp run....
-
Lift Compatibility (M301.4 and M302.4)
A patient lift may be the only means of providing access to certain equipment that cannot meet the technical criteria for transfer surface height (see M301.2.1 and M302.2.1) because of the...
- Resources for Independent Living, Inc. - Richmond and Petersburg, VA
-
Section F: Voting Area
(§307.4) F5 Is there enough room to provide a route at least 36" wide to the registration table and voting stations?...
-
3.3.1. Captioning Hardware Scoping Requirements
For purposes of the cost estimation, the average number of auditoriums per venue type is used to calculate the number of hardware units required per movie theater.20 Table 3-15 presents...
-
11B-202.4 Path of travel requirements in alterations, additions and structural repairs
Rearranging tables, chairs, vending machines, display racks, and other furniture. Repositioning telephones. Adding raised markings on elevator control buttons....
- Kohler C3® 125 Elongated Bidet Toilet Seat With Side Controls and Tank Heater
- NuStep T5 Recumbent Cross Trainer
- Salsbury Industries 61000 Series Single Tier 3 Wide Standard Metal Lockers
- Salsbury Industries 61000 Series Single Tier Standard Metal Lockers