Vertical clearance of 98 inches minimum to accommodate van height at the vehicle parking space, the adjacent access aisle, and on the vehicular route to and from the van-accessible space...
Search Results "Character Height (Raised)"
-
Additional Features of Van-Accessible Parking Spaces
-
11B-703.3.1 Dimensions and capitalization
1.6 mm) Distance between two dots in the same cell1 0.100 (2.5 mm) Distance between corresponding dots in adjacent cells1 0.300 (7.6 mm) Dot height...
-
11B-404.2.10 Door and gate surfaces
stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch (254 mm) bottom smooth surface height...
-
11B-404.2.10 Door and gate surfaces
stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch (254 mm) bottom smooth surface height...
-
11B-703.3.1 Dimensions and capitalization
dots in the same cell1 0.100 (2.5 mm) Distance between corresponding dots in adjacent cells1 0.300 (7.6 mm) Dot height...
-
M303.2.4 Equipment Clearances (Section-by-Section Analysis)
Due to the reorganization of the equipment clearances provision in the final rule, the knee and toe clearance requirements for the other equipment section have been renamed depth and height...
-
H. Your Obligation to Provide Services and Equipment
[Sec. 382.21(a)(4)] On-board wheelchairs must be equipped with footrests, armrests which are movable or removable, adequate occupant restraint systems, a backrest height that permits assistance...
-
III 3.11000 Insurance
ILLUSTRATION: An amusement park requires individuals to meet a minimum height requirement that excludes some individuals with disabilities for certain rides because of a limitation in its...
-
Meeting ANSI Standard S12.60 Requirements
For classrooms where there is no fixed lecture position for the teacher, such as those for lower grades, and where ceiling heights are less than ten feet, the best option is to place most...
-
1.3.1 Overview of NPRM
Equipment to Which Technical Criteria Applies Diagnostic Equipment Used by Patients in Supine, Prone, or Side-Lying Position (M301) Transfer surface, including height...
-
Road Roughness Measurements
(Figure 8) An inertial profiler uses an accelerometer and a non-contacting sensor, such as a laser transducer, to measure height....
-
Measuring Techniques
However, if a very large chair were purchased often, then it would have the effect of raising the 95th percentile, and in turn, changing the design target....
- Stanley SB600 Bifolding Door
- Caroma® USA H2 Zero Waterless Urinal
-
VIII. IMPLEMENTATION AND ENFORCEMENT
Code §§1-2501 et seq., and as such laws have been or may be amended, which claims could have been raised in the DRC/ERC Litigation; and 3....
- Mockett TBR8 Fixed Toilet Brush
- Inclusion Solutions Van Accessible Voter Parking Sign
- Parents Helping Parents, Inc. (PHP)
- Down Syndrome International (DSI)
-
11B-206.4.1 Entrances and exterior ground floor exits
The directional signs must comply with the requirements of Section 11B-703.5 for visual characters. ◼ ETA Editor's Note The ADA requirements included at Subsection 11B-206.4.1...
-
Closed movie captioning (Section-by-Section Analysis)
., sound effects, music, and the character who is speaking). Closed movie captioning is available only to individuals who request it. ...
-
11B-206.4.1 Entrances and exterior ground floor exits
The directional signs must comply with the requirements of Section 11B-703.5 for visual characters. ◼ ETA Editor's Note The ADA requirements included at Subsection 11B-206.4.1...
-
11B-206.4.1 Entrances and exterior ground floor exits
The directional signs must comply with the requirements of Section 11B-703.5 for visual characters. ◼ ETA Editor's Note The ADA requirements included in Subsection 11B-206.4.1...
- EZJamb SlideSet Modern Pocket Door Frame System