The provisions of this code shall apply to the construction, alteration, movement, enlargement, replacement, re- pair, equipment, use and occupancy, location, maintenance, removal and demolition...
Search Results "Signage Location"
Filters
Commonly Searched Documents
-
101.2 Scope
-
What kinds of securement equipment must be provided in buses and vans?
Section 38.23(a) requires vehicles over 22 feet in length to have enough securement locations and devices to secure two wheelchairs, while vehicles 22 feet and under must be able to accommodate...
-
What kinds of securement equipment must be provided in buses and vans?
Section 38.23(a) requires vehicles over 22 feet in length to have enough securement locations and devices to secure two wheelchairs, while vehicles 22 feet and under must be able to accommodate...
-
806.3.2 Notification Devices
Telephones shall be served by an electrical outlet complying with 309 located within 48 inches (1220 mm) of the telephone to facilitate the use of a TTY....
-
508 Chapter 2: Scoping Requirements (Section-by-Section Analysis)
Chapter 2 would contain provisions currently addressed in existing 508 Standards §§ 1194.2 “Application” and 1194.3 “General Exceptions,” thereby locating all scoping provisions in a single...
-
Sec.36.401(d)(1)(i)
(i) Professional office of a health care provider means a location where a person or entity regulated by a State to provide professional services related to the physical or mental health...
-
R308.1.1 Boarding and Alighting Areas
Where a transit shelter is provided, the boarding and alighting area can be located either within or outside of the shelter....
-
Prominent Feature
A natural, cultural, or historic feature located along or adjacent to a trail that is determined by a trail designer or manager to have national, regional, or local distinction or significance...
-
A4.31.3 Mounting Height
The operator button is located at a height of 46 in (1170 mm) if the coin slot of the telephone is at 54 in (1370 mm)....
-
7.2.2.2 Extent of Impracticability
Consider doing so especially if a prominent feature (such as a scenic view, waterfall, or other feature that would be of interest to visitors) is located between the trail terminus and the...
-
Portable Units [4.1.2(6)]
Portable Units [4.1.2(6)] Where portable single-user toilet or bathing units are provided at exterior sites, at least 5%, but no less than one, must be accessible at each location....
-
IV. Training and Technical Assistance from the United States
the United States, in collaboration with the Experts, will provide training to Harris County personnel on the surveying process and the application of the 2010 Standards to polling place locations...
-
Instrumentation for Analysis
An on-site inspection form (Appendix C) was created to collect data on the 11 trail segments including Rotational Penetrometer readings, inspection location in feet from trailhead, ruts,...
-
A4.31.3 MOUNTING HEIGHT
The operator button is located at a height of 46 in (1170 mm) if the coin slot of the telephone is at 54 in (1370 mm)....
-
M301.2.3 Transfer Sides
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface....
-
1134A.8, Item 1
Location....
-
11B-608.5.1 Reserved
controls, faucets, and shower spray unit shall be installed on the side wall opposite the seat 38 inches (965 mm) minimum and 48 inches (1220 mm) maximum above the shower floor and shall be located...
-
§ 38.113(b) Passageway
persons using mobility aids and shall have an unobstructed passageway at least 32 inches wide leading to an accessible sleeping compartment complying with §38.127 of this part or seating locations...
-
11B-705.1.2.2.2 Parallel curb ramps
Detectable warnings at parallel curb ramps shall be located so the edge nearest the curb is 6 inches (152 mm) minimum and 8 inches (203 mm) maximum from the demarcation line at the face...
-
11B-240.1.1 Additions
When the second phase is completed, at least 10 elevated play components must be located on an accessible route, and at least 7 ground level play components, including 4 different types,...
-
Rear Grab Bar
Saving space by locating a lavatory closer to the water closet on the same plumbing wall could only be accomplished by recessing the lavatory so that it does not overlap the clear floor...
-
Designated Aisle Seats
The proposed rule specified that 1% of all seats be designated aisle seats, a quarter of which were to be located on accessible routes and the rest not more than 2 rows from an accessible...
-
11B-221.2.1.6 Specialty seating areas
spaces to be placed in each specialty seating area, those services or amenities shall be provided to individuals with disabilities, and their companions, at other designated accessible locations...
-
240.1.1 Additions
When the second phase is completed, at least 10 elevated play components must be located on an accessible route, and at least 7 ground level play components, including 4 different types,...